Results 91 to 100 of about 160,756 (304)
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source
Crack opening stretch in a plate of finite width [PDF]
The problem of a uniaxially stressed plate of finite width containing a centrally located damage zone is considered. It is assumed that the flaw may be represented by a part-through crack perpendicular to the plate surface, the net ligaments in the plane
Bakioglu, M., Erdogan, F.
core +1 more source
Dynamical Instabilities of Quasi-static Crack Propagation Under Thermal Stress [PDF]
, 2003 We address the theory of quasi-static crack propagation in a strip of glass that is pulled from a hot oven towards a cold bath. This problem had been carefully studied in a number of experiments that offer a wealth of data to challenge the theory.
Bouchbinder, Eran +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Effect of Cracking on Corrosion of Steel in Concrete
International Journal of Concrete Structures and Materials, 2018 It is generally recognized that cracks provide easy access to ingress of chlorides in concrete and hence, the initiation of corrosion of steel in cracked concrete occurs at early stage.
Faiz Uddin Ahmed Shaikh
doaj +1 more source
Predicting failure of specimens with either surface cracks or corner cracks at holes [PDF]
A previously developed fracture criterion was applied to fracture data for surface-cracked specimens subjected to remote tensile loading and for specimens with a corner crack (or cracks) emanating from a circular hole subjected to either remote tensile ...
Newman, J. C., Jr.
core +1 more source
Advanced Engineering Materials, EarlyView.The work demonstrates that strategic wall‐thickness grading in diamond triply periodic minimal surface lattices enables precise tuning of deformation and failure behavior under compression. Different gradation patterns guide how and where the structure collapses, improving energy absorption or promoting controlled brittle failure.
Giovanni Rizza +3 more
wiley +1 more source
Correlating and predicting the air infiltration through the cracks of suspended timber floors [PDF]
, 2001 This paper shows that the visible gap length may be used as a physical parameter when correlating pressure difference to volume flow rate (or air velocity) through the cracks between floorboards and can be termed the Equivalent Crack Length.
Lai, E, McGrath, PT
core +1 more source
Photoswitchable Conductive Metal–Organic Frameworks
Advanced Functional Materials, EarlyView.A conductive material where the conductivity can be modulated remotely by irradiation with light is presented. It is based on films of conductive metal–organic framework type Cu3(HHTP)2 with embedded photochromic molecules such as azobenzene, diarylethene, spiropyran, and hexaarylbiimidazole in the pores.
Yidong Liu +5 more
wiley +1 more source