Results 91 to 100 of about 1,265 (179)

Chemical Modification Mechanism of SiC Substrates in Electrical Discharge Machining. [PDF]

Micromachines (Basel)
Luo Q, Li G, Wang N, Wang S, Lu J, Ke C.
europepmc   +1 more source

Evaluation of cutting speed and surface roughness in WEDM of functionally graded A356-10 wt% Si₃N₄ composite. [PDF]

Sci Rep
Prathap Singh S, Elil Raja D, Ramesh Kumar C, Gnanasekaran K, Bhowmik A, Hussen K, Sowndar S, Sundara Cholan M.   +7 more
europepmc   +1 more source

Archaic humans in the Middle Palaeolithic Levant conducted planned and selective intercepts of aurochs, but not mass hunting. [PDF]

Sci Rep
Yeshurun R, Hartman G, May H, Rivals F, Crater Gershtein KM, Zeigen C, Zaidner Y.   +6 more
europepmc   +1 more source

Stacking Sequence Effect of Basalt/Carbon Hybrid Laminated Composites on Solid Particle Erosion Behavior: From Ambient to Elevated Temperatures. [PDF]

Polymers (Basel)
Özsoy Mİ, Fidan S, Bora MÖ, Ürgün S.   +3 more
europepmc   +1 more source

Experimental Investigation on the Rock-Breaking Efficiency of High-Pressure Jet Drill Rod Perforation in Sandstone Roof. [PDF]

ACS Omega
Li H, Yan P, Cheng Q, Chen J, Chen S, Dong T, Li B, Huang B.   +7 more
europepmc   +1 more source

Polarity-Dependent EDM-Type Degradation in Rolling Bearings Under Low-Speed Unipolar Excitation. [PDF]

Materials (Basel)
Li Z, Cai R, Zhang T, Nie X.
europepmc   +1 more source

The Effect of Material Microstructures on Tool Edge Preparation of PCBN Cutting Tools. [PDF]

Micromachines (Basel)
Huang Z, Wu X, Zhang C, Zhai Y.
europepmc   +1 more source

Tool Wear and Surface Finish in AISI 304 Stainless Steel Dry Turning with Cermet Inserts. [PDF]

Materials (Basel)
Magalhães LC, Sorte NA, Souza MT, Marques A.   +3 more
europepmc   +1 more source

Arc Erosion and Wear Induced Particle Emissions in C/Cu Tribo-Pairs of Pantograph-Catenary System. [PDF]

Materials (Basel)
Dai W, Cheng P, Mao F, Xiao L, Ji D, Shen M, Min L.   +6 more
europepmc   +1 more source

Optimization of EDM parameters for enhanced machining of X37CrMoV5-1 tool steel using taguchi method and regression analysis. [PDF]

Sci Rep
Surani K, Patel H, Sonawane C, Chan CK, Dixit S, Singh S, Mumtaz MA.   +6 more
europepmc   +1 more source