Results 201 to 210 of about 19,859 (309)

Real‐time lithology identification while drilling based on drill cuttings image analysis with ensemble learning

open access: yesDeep Underground Science and Engineering, EarlyView.
A lithology identification while drilling method was developed, integrating an automated cuttings sampling system, a smart drilling rig, and an ensemble learning model. Underground trials achieved 97.42% accuracy in real‐time identification of cuttings lithology and composition, enhancing hazard management and supporting unmanned drilling technology in
Kun Li   +7 more
wiley   +1 more source

Lithium Metal Anode Fabrication: Methods, Challenges, and Strategies

open access: yesEcoEnergy, EarlyView.
Schematic illustration of four representative fabrication techniques for thin lithium metal anodes: extrusion, molten lithium infusion, electroplating, and physical vapor deposition (PVD). ABSTRACT The pursuit of ultra‐high energy‐dense lithium‐metal batteries (LMBs) has reignited the drive to fabricate ultrathin high‐quality lithium metal anodes. This
Ji Hyun Baek, Mi Ji Kang, Ho Won Jang
wiley   +1 more source

Shaking Table Tests and Numerical Analysis of Rocking Vault‐Shaped Segmental Piers Equipped With an Annular Double Sliding System

open access: yesEarthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT To enhance the structural robustness of bridges, a rocking arch‐shaped segmental pier with a double sliding system was previously proposed as a low‐cost solution to protect bridges in developing countries. The rocking behavior is triggered by halting the sliding motion, which increases the horizontal load‐bearing capacity and limits ...
Shengming Feng   +6 more
wiley   +1 more source

Full‐scale Shaking Table Tests on a 10‐story Steel Moment‐resisting Frame Building with Buckling‐restrained Braces

open access: yesEarthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT In February 2023, a comprehensive series of shaking table tests were conducted at the E‐Defense facility, the world's largest three‐dimensional earthquake simulator, on a full‐scale 10‐story steel moment‐resisting frame supplemented with BRBs.
Jun Fujiwara   +9 more
wiley   +1 more source

Concept, Tests, and Optimum Design of Novel Negative Stiffness Friction Dampers for Seismic Protection of Long‐Span Bridges

open access: yesEarthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Viscous dampers (VDs) are widely used to mitigate the excessive responses of long‐span bridges. However, VDs face some intricate challenges in engineering practices, including high damping coefficient requirement, potential base shear amplification and tremendous damping force under high velocity. To address these issues, this study develops a
Ruisheng Ma   +5 more
wiley   +1 more source

Magnetic coupling transforms random snapping into ordered sequences in soft metamaterials. [PDF]

open access: yesSci Adv
Sun H   +7 more
europepmc   +1 more source

Applied Element Modelling of Out‐Of‐Plane Instability in Boundary Elements of Thin RC Walls

open access: yesEarthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Recent earthquakes in Chile (2010) and New Zealand (2011) caused extensive damage to buildings featuring reinforced concrete (RC) structural walls, with observed failure modes including out‐of‐plane instability of slender walls. This buckling‐type response under combined in‐plane and out‐of‐plane loading has also been documented in ...
Andrea Orgnoni   +2 more
wiley   +1 more source

Home - About - Disclaimer - Privacy