Results 171 to 180 of about 9,609 (303)

Critical buckling load optimization of the axially graded layered

, 2015
This study presents critical buckling load optimization of the axially graded layered uniform columns. In the first place, characteristic equations for the critical buckling loads for all boundary conditions are obtained using the transfer matrix method.
openaire   +2 more sources

The Influence of Thermal Conditions on the Stability and Load-Carrying Capacity of Compressed Thin-Walled Composite Profiles. [PDF]

Materials (Basel)
Debski H, Rozylo P, Kuciej M, Falkowicz K, Wysmulski P, Tomczyk A, Mazurek P.   +6 more
europepmc   +1 more source

Lithium Metal Anode Fabrication: Methods, Challenges, and Strategies

EcoEnergy, EarlyView.
Schematic illustration of four representative fabrication techniques for thin lithium metal anodes: extrusion, molten lithium infusion, electroplating, and physical vapor deposition (PVD). ABSTRACT The pursuit of ultra‐high energy‐dense lithium‐metal batteries (LMBs) has reignited the drive to fabricate ultrathin high‐quality lithium metal anodes. This
Ji Hyun Baek, Mi Ji Kang, Ho Won Jang
wiley   +1 more source

Unconventional auricular reconstruction using controlled scaffold buckling and chondrogenic cocktail containing muscle-derived cells. [PDF]

Bioact Mater
Huang N, Lee SKJ, Lee KHK, Wen C, Chang Y, Zhang M, Dong C, Mao C, Wang DM, Ker DFE.   +9 more
europepmc   +1 more source

Shaking Table Tests and Numerical Analysis of Rocking Vault‐Shaped Segmental Piers Equipped With an Annular Double Sliding System

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT To enhance the structural robustness of bridges, a rocking arch‐shaped segmental pier with a double sliding system was previously proposed as a low‐cost solution to protect bridges in developing countries. The rocking behavior is triggered by halting the sliding motion, which increases the horizontal load‐bearing capacity and limits ...
Shengming Feng, Mitsuyoshi Akiyama, Shintaro Kobayashi, Ryosuke Kato, Elisa Vitolo, Hirokazu Takahashi, Shun Arima   +6 more
wiley   +1 more source

Stability of a Compressed Bar Resting on an Elastic Substrate with Stepwise Changes in Parameters. [PDF]

Materials (Basel)
Sadowski M, Marcinowski J, Sakharov V.
europepmc   +1 more source

Full‐scale Shaking Table Tests on a 10‐story Steel Moment‐resisting Frame Building with Buckling‐restrained Braces

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT In February 2023, a comprehensive series of shaking table tests were conducted at the E‐Defense facility, the world's largest three‐dimensional earthquake simulator, on a full‐scale 10‐story steel moment‐resisting frame supplemented with BRBs.
Jun Fujiwara, Jialiang Jin, Jionghui Li, Tianhao Yan, Ryota Nishi, Akiko Kishida, Koichi Kajiwara, Takuya Nagae, Taichiro Okazaki, Tatsuya Asai   +9 more
wiley   +1 more source

Shear Instability Control of Hybrid Small-Scale Plates Embedded in a Polymer Matrix via Shape Memory Alloy Nanofibers. [PDF]

Micromachines (Basel)
Farajpour MR, Danesh M, Shokrani MH, Farajpour A.   +3 more
europepmc   +1 more source

Concept, Tests, and Optimum Design of Novel Negative Stiffness Friction Dampers for Seismic Protection of Long‐Span Bridges

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Viscous dampers (VDs) are widely used to mitigate the excessive responses of long‐span bridges. However, VDs face some intricate challenges in engineering practices, including high damping coefficient requirement, potential base shear amplification and tremendous damping force under high velocity. To address these issues, this study develops a
Ruisheng Ma, Shaodong Jiang, Kun Xu, Qiang Han, Xiuli Du, Kaiming Bi   +5 more
wiley   +1 more source

Research on the Axial Compression Performance of Double C-Section Partially Encased Composite Columns. [PDF]

Materials (Basel)
Zhou M, Qin L, Wen X, Wang F, Weng G.
europepmc   +1 more source