Results 11 to 20 of about 16,861,736 (239)
A crystal plasticity finite element analysis was conducted for predicting forming limits of a ferritic stainless steel. A virtual microstructure crystal plasticity finite element model, or a representative volume element (RVE), was developed, in which ...
Myoung-Gyu Lee +2 more
exaly +2 more sources
Modelling evolution of anisotropy in metals using crystal plasticity [PDF]
Many metals used in modern engineering exhibit anisotropy. A common assumption when modelling anisotropic metals is that the level of anisotropy is fixed throughout the calculation. As it is well understood that processes such as cold rolling, forging
Chaloupka, Ondrej
core +7 more sources
A texture component crystal plasticity finite element method for scalable anisotropy simulations [PDF]
This progress report introduces a crystal plasticity finite element method which includes and updates the texture of polycrystalline matter for physically based simulations of large strain forming operations. The approach works by directly mapping a set of discrete texture components into a crystal plasticity finite element method.
Raabe, D. +3 more
openaire +2 more sources
Finite element model creation and stability considerations of complex biological articulation : the human wrist joint [PDF]
The finite element method has been used with considerable success to simulate the behaviour of various joints such as the hip, knee and shoulder. It has had less impact on more complicated joints such as the wrist and the ankle.
Stansfield, B.W. +2 more
core +4 more sources
Application of finite element methods to photonic crystal modelling [PDF]
Photonic crystals are materials with periodically modulated dielectric constant, through which certain frequencies of electromagnetic radiation cannot propagate; the luminary analogues of semiconductors.
Generowicz, J.M. +5 more
core +2 more sources
Data of paper: A pseudorandom based crystal plasticity finite element method for grain scale polycrystalline material ...
Ji, Hansong, Ji, H (via Mendeley Data)
core +2 more sources
Application of the continuum shell finite element SHB8PS to sheet forming simulation using an extended large strain anisotropic elastic–plastic formulation [PDF]
http://link.springer.com/article/10.1007%2Fs00419-012-0620-xThis paper proposes an extension of the SHB8PS solid–shell finite element to large strain anisotropic elasto-plasticity, with application to several non-linear benchmark tests including sheet ...
BALAN, Tudor +3 more
core +1 more source
Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source
Schematic representation of modes of microcrack nucleation, growth and temporary arrestment at different boundaries, with the criteria for crack propagation in three scenarios: (1) large notch, (2) defect/small sharp notch, and (3) long crack. This work revisits and integrates results on the fatigue behavior of advanced bainitic steels (in particular ...
Lucia Morales‐Rivas
wiley +1 more source
Additive manufacturing introduces pronounced microstructural and crystallographic anisotropy in Ni‐based superalloys, resulting in orientation‐dependent creep deformation and damage. This review identifies the key microstructural origins of creep anisotropy, examines their influence on dominant deformation mechanisms, and highlights processing ...
Chandan Kumar +3 more
wiley +1 more source

