Results 41 to 50 of about 35,043 (231)
Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov +4 more
wiley +1 more source
Models for Metal Hydride Particle Shape, Packing, and Heat Transfer
A multiphysics modeling approach for heat conduction in metal hydride powders is presented, including particle shape distribution, size distribution, granular packing structure, and effective thermal conductivity.
Asakuma +49 more
core +1 more source
Phase Field Failure Modeling: Brittle‐Ductile Dual‐Phase Microstructures under Compressive Loading
The approach by Amor and the approach by Miehe and Zhang for asymmetric damage behavior in the phase field method for fracture are compared regarding their fitness for microcrack‐based failure modeling. The comparison is performed for the case of a dual‐phase microstructure with a brittle and a ductile constituent.
Jakob Huber, Jan Torgersen, Ewald Werner
wiley +1 more source
During coal seam mining, pore gas pressure and in-situ stress exhibit dynamic coupling characteristics involving multi-cycle synchronous loading and unloading.
Shugang LI +7 more
doaj +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Flow-Induced Stresses and Displacements in Jointed Concrete Pipes Installed by Pipe Jacking Method [PDF]
Transient flows result in unbalanced forces and high pressure in pipelines. Under these conditions, the combined effects of flow-induced forces along with sudden pipe displacements can create cracks in the pipeline, especially at the junctions.
Ahmad, Sajjad +3 more
core +2 more sources
Polymorph engineering in ErMnO3 enables low‐voltage, forming‐free threshold switching with tunable negative differential resistance. Conducting orthorhombic regions embedded in an insulating hexagonal matrix provide controlled Joule‐heating‐enhanced Poole–Frenkel transport. The hexagonal phase prevents excessive heating and breakdown.
Rong Wu +8 more
wiley +1 more source
An experimental study of CH4 displacement by CO2 under varying initial reservoir pressures
ObjectiveThis study aims to reveal the evolutionary patterns of reservoir parameters during the CO2-enhanced coalbed methane (CO2-ECBM) recovery and the impact of initial reservoir pressure on CBM recovery by gas injection.
Jiang XU +5 more
doaj +1 more source
Regiorandom Polythiophenes for Fully Stretchable Electrochemical Transistors and Logic Circuits
Regiorandom (RRa) polythiophenes, once regarded as unsuitable for electronics, exhibit exceptional switching performance via volumetric electrochemical doping. Optimized RRa‐based organic electrochemical transistors (OECTs) achieve a high on/off ratio (≈104), stable operation under 200% strain, and enable fully stretchable logic gates, demonstrating ...
Dong Hyun Park +6 more
wiley +1 more source
Effect of ageing time on properties of hot-mix asphalt containing recycled concrete aggregates [PDF]
[Abstract] This study describes a laboratory evaluation on the effect of ageing time on the primary properties of hot-mix asphalt (HMA) containing recycled concrete aggregates (RCA) from construction and demolition waste (CDW).
Pasandín, A.R., Pérez Pérez, Ignacio
core +2 more sources

