Results 61 to 70 of about 540,012 (294)
Modeling and damping of high-frequency leakage currents in PWM inverter-fed AC motor drive systems [PDF]
, 1995 This paper presents an equivalent circuit for high-frequency leakage currents in pulsewidth modulation (PWM) inverter-fed AC motors, which forms a series resonant circuit.
Akagi, Hirofumi, Ogasawara, Satoshi
core +1 more source
All current-mode frequency selective circuits
Electronics Letters, 1989 This letter proposes an entirely new method for performing analogue signal filtering. All circuits are based upon current amplifiers but derived from well-known voltage amplifier circuits. These circuits possess the same sensitivity properties as their voltage amplifier counterparts.
G.W. Roberts, A.S. Sedra
openaire +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
A New Translinear-Based Dual-Output Square-Rooting Circuit
Active and Passive Electronic Components, 2008 A new wide input range square-rooting circuit is presented. The proposed circuit consists of a dual translinear loop, an absolute value circuit, and current mirrors. A current-mode technique is used to provide wide input range with simple circuitry.
Montree Kumngern, Kobchai Dejhan
doaj +1 more source
Advanced Engineering Materials, EarlyView.High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source
Voltage-Mode Multifunction Biquadratic Filters Using New Ultra-Low-Power Differential Difference Current Conveyors [PDF]
, 2013 This paper presents two low-power voltage-mode multifunction biquadratic filters using differential difference current conveyors. Each proposed circuit employs three differential difference current conveyors, two grounded capacitors and two grounded ...
Dejhan, K. +4 more
core +1 more source
Strong Coupling of a Cavity QED Architecture for a Current-biased Flux Qubit
, 2011 We propose a scheme for a cavity quantum electrodynamics (QED) architecture for a current-biased superconducting flux qubit with three Josephson junctions.
Kim, Mun Dae, Moon, K.
core +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, EarlyView.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
Current-Mode Third-Order Quadrature Oscillator Using CDTAs
Active and Passive Electronic Components, 2009 This paper describes a current-mode third-order quadrature oscillator based on current differencing transconductance amplifiers (CDTAs). Outputs of two current-mode sinusoids with 90° phase difference are available in the quadrature oscillator circuit ...
Jiun-Wei Horng
doaj +1 more source