Results 21 to 30 of about 157,722 (307)
A novel miniature superconducting converter for 1 kA magnets [PDF]
A miniature full-wave converter to control the current of a superconducting magnet is developed and tested in our institutes. Typical design values of the device are: AC voltage of 35 V, current of 7 A, and frequency 50-60 Hz; DC voltage o f f 0.2 V, and
Fedorovsky, Michael A. +3 more
core +3 more sources
This paper analyzes the presence of undesired quantization-induced perturbations (QIP) in a dc-dc buck-boost converter using a two-loop digital current control.
Catalina González-Castaño +4 more
doaj +1 more source
Floating Interleaved Boost Converter with Zero-Ripple Input Current Using Variable Inductor
A zero-ripple input current is known to improve the lifetime of battery sets and fuel cells and to assure maximum power point tracking in PV panels.
Hector Hidalgo +5 more
doaj +1 more source
Linearized large signal modeling, analysis, and control design of phase-controlled series-parallel resonant converters using state feedback [PDF]
This paper proposes a linearized large signal state-space model for the fixed-frequency phase-controlled series-parallel resonant converter. The proposed model utilizes state feedback of the output filter inductor current to perform linearization.
Aboushady, Ahmed A. +3 more
core +3 more sources
Pemodelan Fuzzy Logic Control untuk Pengendali PWM pada Buck Converter
Recently the switching mode used in a buck converter is controlled by pulse width modulation (PWM) which has relatively higher efficiency compared to a linear power supply system. In general, there are two problems that often occur in the buck converter,
Helmy Mukti Himawan +2 more
doaj +1 more source
FPGA implementation of online finite-set model based predictive control for power electronics [PDF]
Recently there has been an increase in the use of model based predictive control (MBPC) for power-electronic converters. MBPC allows fast and accurate control of multiple controlled variables for hybrid systems such as a power electronic converter and ...
Jacxsens, Michiel +3 more
core +2 more sources
Design and implementation of a current controlled single stage single phase integrated AC/DC isolated Power Factor Correction (PFC) converter is presented in this paper. With the integrated topology reduces the number control switches.
Mopidevi Subbarao +2 more
doaj +1 more source
A grid interface current control strategy for DC microgrids
In this paper, a grid interface current control strategy is presented for a DC microgrid, which aims to reduce the disturbance from PV generation and the load variation to the main grid without a grid interface converter.
Muhannad Alshareef +3 more
doaj +1 more source
Design Considerations for a Voltage-Boosting DC-AC Modular Multilevel Converter [PDF]
The Modular Multilevel Converter (M2C) is a relatively recent addition to the family of multilevel power converters. This paper describes the topology, dynamic phasor modeling, and operation of a voltage boosting DC-AC Modular Multilevel Converter.
Ramírez Prieto, Dionisio +3 more
core +1 more source
The engine generator system with a diode rectifier causes harmonic currents in the generator which can affect generator efficiency and may produce torque oscillations. Using an active rectifier instead of a diode rectifier helps us to improve the current
Htar Su Hlaing +3 more
doaj +1 more source

