Results 11 to 20 of about 1,015,715 (265)
Silicon Photomultiplier Sensor Interface Based on a Discrete Second Generation Voltage Conveyor
Sensors, 2020 This work presents the design of a discrete second-generation voltage conveyor (VCII) and its capability to be used as electronic interface for silicon photomultipliers. The design addressed here exploits directly at the transistor level, with commercial
Vincenzo Stornelli +4 more
doaj +1 more source
Novel First Order Current Mode MOS-C Phase Shifters
Elektronika ir Elektrotechnika, 2018 In this work, novel first order MOS-C phase shifter structures are proposed in NMOS and PMOS configurations. Core circuits consist of only three transistors and a single capacitor.
Deniz Ozenli +3 more
doaj +1 more source
A Compact Fully Electronically Tunable Memristive Circuit Based on CCCDTA with Experimental Results
Micromachines, 2023 This work presents a flux-controlled memristor structure employing a Current-Controlled Current Differencing Transconductance Amplifier (CCCDTA) with a grounded capacitor.
Deniz Ozenli
doaj +1 more source
Materials Research Express, 2021 Micro-arc oxidation (MAO) coatings were prepared on the AZ31 Mg alloy under the constant/gradient current control modes. The effects of current output modes on the growth rate, energy consumption, microstructure, and corrosion resistance of MAO coatings ...
Junwen Yuan +5 more
doaj +1 more source
IEEE Access, 2020 This paper presents a non-inverting buck-boost converter for high-voltage automotive applications. The converter includes a newly proposed controller chip and four off-chip NMOS power transistors with two bootstrap capacitors.
Jiho Moon +7 more
doaj +1 more source
CMOS Current-mode Operational Amplifier [PDF]
ESSCIRC '92: Eighteenth European Solid-State Circuits conference, 1992 A fully differential-input differential-output current-mode operational amplifier (COA) is described. The amplifier utilizes three second generation current-conveyors (CCII) as the basic building blocks. It can be configured to provide either a constant gain-bandwidth product in a fully balanced current-mode feedback amplifier or a constant bandwidth ...
openaire +3 more sources
Low Voltage High Performance CMOS Current Mode Four-Quadrant Analog Multiplier Circuit [PDF]
Radioengineering, 2022 This paper describes a new CMOS current mode four-quadrant analog multiplier circuit. The proposed design is based on a high performance squarer cell, whose main core is realized by the up–down topology trans-linear loop using flipped voltage followers ...
T. Ettaghzouti +3 more
doaj
High-Speed Current-Mode Full-Adder with Carbon Nanotube Technology
Majlesi Journal of Electrical EngineeringThe relationship between the amount of energy consumption and the circuit speed to change the design efficiency is an important challenge in designing digital circuits.
Mehdi Habibollahi, Ali Saghafinia
doaj +1 more source
Design and Implementation of a Low-Power Low-Cost Digital Current-Sink Electronic Load ‡
Energies, 2019 Electronic load (e-load) is essential equipment for power converter performance test, where a designated load profile is executed. Electronic load is usually implemented with the analog controller for fast tracking of the load profile reference.
Wei Jiang +5 more
doaj +1 more source
Biosensors, 2019 Accurate and cost-effective integrated sensor systems for continuous monitoring of pH and blood gases continue to be in high demand. The capacity of ion-selective and Gas-sensitive field effect transistors (FETs) to serve as low-power sensors for ...
Shahriar Jamasb
doaj +1 more source