Results 281 to 290 of about 1,349,956 (360)
Multiscale Modeling of Process‐Induced Defects in Fused Filament Fabrication‐Printed Materials
Advanced Engineering Materials, EarlyView.This study presents a predictive multiscale modeling tool for defect analysis of fused filament fabricated‐printed materials and their performance prediction using a mechanistic data science‐based reduced‐order modeling approach. Process‐induced defects are inherent to additively manufactured parts and significantly influence the performance of printed
Satyajit Mojumder +3 more
wiley +1 more source
Direct Consolidation of Copper–Graphene Composite by Rotary Swaging
Advanced Engineering Materials, EarlyView.The applicability of the rotary swaging method for preparation of electroconductive copper–graphene composite by direct consolidation of powders is proven. The consolidated material features advantageous microstructure featuring fine grains and twins, with homogeneous distribution of graphene, primarily along the twin boundaries, which contribute to ...
Radim Kocich +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates the mechanical properties of Carbon/Aramid intraply hybrid fiber‐reinforced Elium composites under 6 months of water aging. After aging, flexural strength decreases by 25.89%, tensile strength by 4.40%, and fracture toughness by 21.56%.
Muhammed Huseyin Guzel, Gurol Onal
wiley +1 more source
Advanced Engineering Materials, EarlyView.The share of technical thermoplastics is expected to grow further in the e‐mobility segment. In this study, a detailed temperature‐based tribological characterization of technical thermoplastics is performed. The tribological properties are discussed in terms of the dynamic mechanical properties of polymers at different ambient temperatures. A proof of
Harsha Raghuram +2 more
wiley +1 more source
The Study of the Effect of Blade Sharpening Conditions on the Lifetime of Planar Knives During Industrial Flatfish Skinning Operations. [PDF]
Materials (Basel)Sutowski P, Zieliński B, Nadolny K.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Primary phases and a fatigue crack are studied in a forged blank of an aluminum alloy using synchrotron and laboratory X‐ray computed tomography. To image the crack, the fatigue test is interrupted, and a static tensile load is applied to open the crack.
Jakob Schröder +6 more
wiley +1 more source
The Design and Evaluation of Twisted HDPE Grass-Cutting Lines: A Performance Comparison with Commercial Nylon. [PDF]
Polymers (Basel)Pholsuwan A +4 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.In this research, ZrC coatings are evaluated against various counterprobes at the microscale using novel super‐stiff atomic force microscopy cantilevers. The chemical composition of the coating is shown to be an important factor influencing coating hardness and Young's modulus, while surface roughness, counterprobe hardness, and surface energy are the ...
Piotr Jenczyk +4 more
wiley +1 more source
Co-Application of Sheep Manure and Azotobacter Biofertilizer Enhances Growth, Yield, Essential Oil Profile, and Antioxidant Activity in Summer Savory. [PDF]
Biology (Basel)Benli U, Yaldiz G, Camlica M.
europepmc +1 more source