Results 181 to 190 of about 3,023,757 (394)

Cutting-Force Modeling Study on Vibration-Assisted Micro-Milling of Bone Materials. [PDF]

Micromachines (Basel), 2023
Shang P, Zhang H, Liu X, Yang Z, Liu B, Liu T.   +5 more
europepmc   +1 more source

Application of the Wigner distribution to monitoring cutting tool condition [PDF]

This thesis is about the application of the Wigner distribution to cutting tool monitoring and control. After reviewing traditional methods, a new method is proposed.
Zheng, Kougen
core  

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Effect of Duty Cycle on Cutting Force for Ultrasonic Vibration-Assisted Milling Carbon Fiber-Reinforced Polymer Laminates. [PDF]

Materials (Basel), 2023
Zhang Y, Ren J, Zhou J.
europepmc   +1 more source

207 Development of Cutting Force Measurement Technique for Milling Process with Small Diameter End Mill

, 2012
Tadao KAWAI, Masakazu NONAKA
openalex   +2 more sources

A practical method to monitor tool wear in end milling using a changing cutting force model that requires no additional sensors

, 2021
Kazuki Kaneko, Isamu NISHIDA, Ryuta Sato, Keiichi SHIRASE   +3 more
openalex   +2 more sources

Feed Cutting Force Analysis Using Discrete Wavelet Transform in Drilling of Aluminium Matrix Composite

This paper presents an analysis of the cutting forces during the drilling of a ceramic fibre-reinforced aluminium matrix composite. The machining was carried out under dry drilling conditions and with minimum lubrication of the cutting zone.
Paweł Karolczak, Marcin Kasprzak, Maciej Kowalski   +2 more
core   +1 more source

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

Advanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar, Dhanadeep Dutta, G. Bharat Reddy   +2 more
wiley   +1 more source

Experimental Study on the Influence of Wire-Saw Wear on Cutting Force and Silicon Wafer Surface. [PDF]

Materials (Basel), 2023
Liang L, Li S, Lan K, Yu R, Wang J, Zhao W.   +5 more
europepmc   +1 more source

Modeling of Friction Force on the Rake Face under the Influence of Cutting Temperature

, 2013
Yuuki KUROSAWA, Junnosuke Saigawa, Tohru IHARA   +2 more
openalex   +2 more sources