Results 201 to 210 of about 3,569,796 (283)
Additive manufacturing introduces pronounced microstructural and crystallographic anisotropy in Ni‐based superalloys, resulting in orientation‐dependent creep deformation and damage. This review identifies the key microstructural origins of creep anisotropy, examines their influence on dominant deformation mechanisms, and highlights processing ...
Chandan Kumar +3 more
wiley +1 more source
Dynamic characteristics and constitutive model of improved coarse-grained roadbed filler under traffic cyclic loading. [PDF]
Wu W, Liang B, Shan S, Ouyang T.
europepmc +1 more source
Electrodeposition in Structural Lattices of Variable Architectures
Electrodeposition enables geometry‐sensitive, autonomous void filling while simultaneously tuning chemical and mechanical properties. The development of approaches that can autonomously fill and heal material voids and yield composites with tailorable properties is increasingly relevant in engineering.
Yeong‐Man Kwon +3 more
wiley +1 more source
Damage evolution mechanism and energy response of sandstone under triaxial compression. [PDF]
Zhou B, Wu X, Li B, Li J.
europepmc +1 more source
Cyclic stress-strain relation of Granular Material under Anisotropic Confining Pressure
Sato, Masayoshi, Shamoto, Yasuhiro
openaire +1 more source
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika +5 more
wiley +1 more source
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo +15 more
wiley +1 more source
Debonding mechanisms of fully grouted rock bolts driven by adhesive-ring cracking. [PDF]
Liang D, Zhang N, Lin F, Pan D, Rong H.
europepmc +1 more source
Accelerated in situ formation of TiB and TiC in Ti–5Al–2.5Sn–B4C is driven by transient liquid phase formation, which enhances particle reactions and microstructural evolution. This process increases hardness and establishes a coupled relationship between sintering temperature and reinforcement content, strongly influencing porosity in the resulting ...
Fernando. Y. Kojima, Juliano. Soyama
wiley +1 more source
Laboratory investigation of wetting induced deformation in unsaturated expansive soil during shield tunnelling in Yangzhou, China. [PDF]
Dai Q, Liu X, Qian H.
europepmc +1 more source

