Results 251 to 260 of about 3,700,789 (338)

Mechanical Properties of Latex-Modified Cement Stone under Uniaxial and Triaxial Cyclic Loading. [PDF]

Polymers (Basel)
Tian Q, Yang L, Zhang J, Xing Z.
europepmc   +1 more source

Study on the failure and acoustic emission characteristics of coal under graded cyclic loading and unloading stress paths. [PDF]

Sci Rep
Duan M, Lu M, Ban R, Yang K, Lyu X, Jiang C, Hu X, Tang J.   +7 more
europepmc   +1 more source

Cyclic loading failed to promote growth in a pig model of midfacial hypoplasia. [PDF]

J Anat
Herring SW, Rafferty KL, Shin DU, Smith K, Baldwin MC.   +4 more
europepmc   +1 more source

Study on Pore Water Pressure Model of EICP-Solidified Sand under Cyclic Loading. [PDF]

Materials (Basel)
Li G, Li Y, Hua X, Liu J, Yang S, Zhang Y.   +5 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Accelerating Cyclic Loading

2018 IEEE 7th World Conference on Photovoltaic Energy Conversion (WCPEC) (A Joint Conference of 45th IEEE PVSC, 28th PVSEC & 34th EU PVSEC), 2018
In this work, we performed four variations of cyclic load testing on four groups of modules using the LoadSpot tool. Each group first underwent 50 thermal cycles (TC50), 10 humidity-freeze cycles (HF10), and a 2400 Pa static load. Then, the baseline group was tested using standard cyclic loading conditions from IEC 62782, another with double the ...
Seigneur, Hubert, Lincoln, Jason, Schneller, Eric, Gabor, Andrew M.   +3 more
openaire   +2 more sources

Cyclic Pressuremeter Tests for Cyclic Lateral Loads

Offshore Technology Conference, 1984
ABSTRACT The results of thirteen cyclic pressuremeter tests performed in hand augured holes on a stiff clay are presented. These tests show that the slope of the unload-reload loop stabilizes after only a few cycles but that the strain at the peak of the cycle continues to cumulate long after the slope of the loop ...
J.L. Briaud, K.B. Riner, S. Ohya
openaire   +1 more source

Constitutive model for monotonic and cyclic loading on anisotropic clays

, 2020
In the present work, a constitutive model for anisotropic clays is proposed and evaluated under monotonic and cyclic loading.
W. Fuentes, D. Mašín, J. Duque
semanticscholar   +1 more source

Pile Load Tests: Cyclic Loads and Varying Load Rates

Journal of the Geotechnical Engineering Division, 1981
Two series of axial load tests were performed on four 14-in. (356-mm) diam, open-end, steel pipe piles at an interval of about 320 days. Pile lengths of 40 ft or 50 ft (12.2 or 15.2 m) were installed below conductors driven to depths ranging from 115 ft to 320 ft (35 m to 98 m) into a strong underconsolidated clay. Each pile was subjected to as many as
Leland M. Kraft, Edward A. Verner, William R. Cox   +2 more
openaire   +2 more sources

Pore Pressure Development During Cyclic Loading

Journal of Geotechnical Engineering, 1983
A mathematical expression is developed for the relationship between the excess pore pressure buildup in sands during cyclic loading and the normalized number of cycles. This expression is based on the equations proposed by previous investigators, but the effects of anisotropic stress conditions are represented more accurately. The new method is capable
CHANG, CS, KUO, CL, SELIG, ET
openaire   +2 more sources

Strain-sensitive electrical conductivity of carbon nanotube-graphene-filled rubber composites under cyclic loading.

Nanoscale, 2019
Conductive rubber nanocomposites have been attracting interest for strain sensing applications owing to their large deformation and high sensitivity. In this paper, the strain sensing behavior of room temperature vulcanized (RTV) hybrid silicone rubber ...
Heng Yang, X. Yao, Li Yuan, Linhui Gong, Yinghua Liu   +4 more
semanticscholar   +1 more source