Results 21 to 30 of about 391,160 (161)
Non-continuous Froude number scaling for the closure depth of a cylindrical cavity [PDF]
, 2006 A long, smooth cylinder is dragged through a water surface to create a cavity with an initially cylindrical shape. This surface void then collapses due to the hydrostatic pressure, leading to a rapid and axisymmetric pinch-off in a single point ...
Arjan van der Bos +6 more
core +4 more sources
Shakedown behaviour of composite cylinders with cross holes [PDF]
, 2010 In this study, both the lower and upper bound shakedown limits of a closed-end composite cylinder with or without a cross hole subject to constant internal pressure and a cyclic thermal gradient are calculated by the Linear Matching Method (LMM ...
Chen, Haofeng +3 more
core
Pressure fluctuations on the surface of a cylinder in uniform flow [PDF]
The problem of determining the pressure fluctuations induced on the surface of a cylinder by the fluctuating wake behind it is formulated. A formal solution relating the unsteady surface pressure field to the velocity field in the wake is derived and ...
Ayoub, A., Karamcheti, K.
core +1 more source
, 1972 System for quantitative determination of leak rates in large pressurized compartments is described. Method uses pressure reference cylinder placed in thermal contact with internal environment of compartment.
Morris, R. G., Rose, A. L.
core +1 more source
Flow and Drag Formulas for Simple Quadrics [PDF]
The pressure distribution and resistance found by theory and experiment for simple quadrics fixed in an infinite uniform stream of practically incompressible fluid are calculated. The experimental values pertain to air and some liquids, especially water;
Zahm, A. F.
core +1 more source
Full- and Reduced-order Model of Hydraulic Cylinder for Motion Control [PDF]
, 2017 This paper describes the full- and reduced-order models of an actuated hydraulic cylinder suitable for system dynamics analysis and motion control design.
Ruderman, Michael
core +2 more sources
Measurements of Pressure Distribution around Eccentric Cylinders, with the Outer Cylinder Rotating
Bulletin of JSME, 1969 We measured the pressure distribution around eccentric rotating cylinders, of which the outer cylinder rotates, covering a wide range from a laminar flow to a fully developed turbulent flow in the case of various eccentricity ratios and clearance ratios.
Yutaka YAMADA, Koichi NAKABAYASHI
openaire +3 more sources
In-Cylinder Pressure Estimation from Rotational Speed Measurements via Extended Kalman Filter. [PDF]
Sensors (Basel), 2023 Quartullo R +4 more
europepmc +1 more source
Structural behavior of tapered inflated fabric cylinders under various loading conditions [PDF]
, 1971 Method analyzes inflatable structures and considers axial loads, torsional moment, and internal pressure. Behavior depends on anistropic nature and large deflection stress-strain characteristics of fabric material.
Kovalevsky, L., Risk, F. L.
core +1 more source
High pressure study of BaFe2As2 - role of hydrostaticity and uniaxial stress
, 2009 We investigate the evolution of the electrical resistivity of BaFe2As2 single crystals with pressure. The samples used were from the same batch grown from self flux and showed properties that were highly reproducible. Samples were pressurised using three
Alireza P L +12 more
core +1 more source