Results 1 to 10 of about 66,557 (268)

Dynamics of the Complex System With Elastic and Visco-Elastic Inertial Interlayers

Engineering Transactions, 2014
In this paper is given the dynamic analysis of the free and forced vibration problems of a complex system with elastic and visco-elastic inertial interlayers.
K. CABANSKA-PŁACZKIEWICZ
doaj   +1 more source

Performance-Based Design of Tall Timber Buildings Under Earthquake and Wind Multi-Hazard Loads: Past, Present, and Future

Frontiers in Built Environment, 2022
The rapid growth of the urban population and associated environmental concerns are challenging city planners and developers to consider sustainable and cost-efficient building systems. Timber-based buildings, such as sustainable systems, are increasingly
S. Tesfamariam
doaj   +1 more source

Study of the Effect of Static Eccentricity on Vibration Damping Properties of Squeeze Film Dampers Considering the Two-Phase Flow Case

Lubricants
To analyze the effect of static eccentricity on the air ingestion distribution and vibration damping properties of the SFD, a numerical simulation study of SFDs considering two-phase flow was carried out based on CFD using a transient solution method and
Hailun Zhou, Liang Fang, Ming Zhang, Gangyi Cao, Jianyang Su   +4 more
doaj   +1 more source

Application of Smoothed Particle Hydrodynamics to Structural Cable Analysis

Applied Sciences, 2020
In this study, a numerical model is proposed for the analysis of a simply supported structural cable. Smoothed particle hydrodynamics (SPH)—a mesh-free, Lagrangian method with advantages for analysis of highly deformable bodies—is utilized to model a ...
A. Ersin Dinçer, Abdullah Demir
doaj   +1 more source

Research on the Influence of the Mounting Configuration on the Elastic Characteristics and Energy Dissipation Capacity of Multi-Leaf Springs for Truck Vehicles

Energies
This paper presents selected results of experimental tests on multi-leaf springs used in the dependent suspensions of trucks. The main objective of this research was to determine the dissipation energy in the actual spring structure for various methods ...
Wieslaw Krason, Pawel Bogusz, Jozef Wysocki   +2 more
doaj   +1 more source

Zero/low overshoot conditions based on maximally‐flatness for PID‐type controller design for uncertain systems with time‐delay or zeros

IET Control Theory & Applications
This paper extends the characteristic ratio approach using novel inequalities to ensure zero/low overshoot for linear‐time‐invariant systems with zeros.
Mehmet Canevi, Mehmet Turan Söylemez
doaj   +1 more source

Composites’ damping – an actual challenge

eXPRESS Polymer Letters, 2017
editorial
J. Karger-Kocsis, Z. A. Mohd Ishak
doaj   +1 more source

Synergy of Interlaminar Glass Fiber Hybridization on Mechanical and Dynamic Characteristics of Jute and Flax Fabric Reinforced Epoxy Composites

Journal of Natural Fibers, 2022
Natural fiber composites (NFC) exhibit good specific mechanical properties in comparison to synthetic fiber composites (SFC). The study investigates interlaminar glass (G) fiber hybridized jute (J) and flax (F) reinforced epoxy composites designated as ...
Harshad Pingulkar, Ashok Mache, Yashwant Munde, I. Siva   +3 more
doaj   +1 more source

Design Parameters Affecting the Performance of Vortex-Induced Vibration Harvesters

Micromachines
Vortex-induced vibration harvesters are usually equipped with small piezoelectric patches mounted near the cantilever clamp, where the largest longitudinal stress occurs.
Alberto Pasetto, Michele Tonan, Federico Moro, Alberto Doria   +3 more
doaj   +1 more source

Simulation of Nose Landing Gear Shimmy with Flexible Airframe Considered [PDF]

Xibei Gongye Daxue Xuebao, 2018
Shimmy stability of the nose landing gear of an aircraft is studied in this paper. Firstly, Shimmy model was built considering the dynamic characteristics of the airframe. Then the critical damping, critical velocity and frequency range of the shimmy are

doaj   +1 more source