Results 71 to 80 of about 858,761 (200)
Ain Shams Engineering JournalMaintaining frequency stability in low inertia microgrids with high renewable energy source (RES) penetration is a major problem. To resolve this issue, the use of the virtual synchronous generator (VSG) was proposed in the literature.
Youssef Awda, Maad Alowaifeer
doaj +1 more source
A study of joint damping in metal plates
, 2006 For satellite applications the determination of the correct dynamic behaviour and in particular the structural damping is important to assess the vibration environment for the spacecraft subsystems and ultimately their capability to withstand the launch ...
Walker, S.J.I. +2 more
core +1 more source
Calculation of the Added Mass and Damping Forces on Supercavitating Bodies [PDF]
, 2001 A linearized formulation for the unsteady forces experienced by supercavitating bodies is developed in terms of their added mass and damping coefficients. The formulation is general, but is applied here using an axisymmetric base flow.
Fine, Neal E. +2 more
core
Limiting Stiffness and Damping Coefficients of Foil Bearing
, 2005 The limiting values of load capacity, stiffness and damping coefficients for a foil bearing are presented. The necessary conditions for high bearing numbers (journal operating at high speed) are obtained by simplifying the compressible Reynolds equation.
Rao, T. V. V. L. N., Sawicki, Jerzy T.
core +1 more source
Reduced joint models for damping design of multi-jointed structures [PDF]
, 2014 − Design of damping in multi-jointed structures is studied here. − Dissipation sources are viscoelastic behavior and contact/friction at joints interfaces. − Reduction on meta-models of nonlinear joints models is investigated.
BALMES, Etienne +2 more
core
Flexible joints performance assessment of additive manufacturing FDM 3D printed TPU.
PLoS ONEGiven the increasing adoption of flexible 3D-printed joints in the field of robotics, it is essential to characterize the stiffness/spring coefficient and damping of printed specimens to understand the effects of various processing parameters and their ...
Daniel Rodríguez-Flores +3 more
doaj +1 more source
LubricantsThis study aims to investigate the dynamic behavior of water-lubricated stern bearings during service. A transient rotor dynamics numerical model is developed to research the effects of operating conditions and critical structural parameters on the ...
Hongtao Zhu +4 more
doaj +1 more source
Damping and stiffness coefficients variations.
, 2013 Damping (A) and stiffness (B) coefficients estimated for adolescents (grey line) and adults (black line) with Down syndrome over the three cycles following the first flexion. F1–F4, peak angles of flexion; E1–E4, peak angles of extension.
Antonino Casabona (22594) +4 more
core +1 more source
On the damped oscillations equation with with variable coefficients. [PDF]
Quarterly of Applied Mathematics, 1958 openaire +1 more source
MPPT Reactive Control Algorithm for Heaving Wave Energy Converters With Power Setpoint Capabilities
IEEE AccessReactive control is a popular method for maximizing wave energy absorption in wave energy converters (WECs). This technique involves adjusting the damping and stiffness coefficients of the WEC to align its natural frequency with the frequency of incoming
Abdin Y. Elamin +7 more
doaj +1 more source