Results 61 to 70 of about 33,145 (267)
Take three-fixing-lobe bearings,which are not concentric supporting elastic Effort rotor as the research subject.Based on considering the stiffness and damping characteristics of journal bearing,dynamic coefficients of journal bearing and damping ...
阎庆华, 安琦
doaj
Cyclic shearing characteristics of calcareous sand-snake skin-inspired interfaces
In marine geotechnical engineering, the dynamic response of the calcareous sand-structure interfaces is critical to the overall stability of structures.
CUI Hao 1, 2 , LIU Hanlong 2, 3, XIAO Yang 2, 3
doaj +1 more source
Two‐photon grayscale lithography (2GL) enables high‐speed and precise 3D printing of thermolyzed silica glass microstructures with optical‐grade surface quality, high quality factors, and mechanical strength utilizing a custom‐made pre‐glass resist based on polyhedral oligomeric silsesquioxane (POSS) modified with a high‐sensitivity Norrish type II ...
Jonathan L. G. Schneider +4 more
wiley +1 more source
Study of the effect of specimen size and frequency on the structural damping property of beam
It is said that the parameters that characterize structural damping, i.e., the loss factor, are identical to the material of the specimen, but in actuality, the damping property is sometimes affected by specimen size or the frequency.
Shozo KAWAMURA +3 more
doaj +1 more source
Thermally Robust Spin–Orbit Torque Switching in Low‐Resistivity Mo‐Alloyed β‐W Heterostructures
Mo‐alloyed β‐W heterostructures exhibit enhanced spin‐orbit torque efficiency, reduced resistivity and switching current density, and reliable operation from −50 to +150°C. The optimized W87.3Mo12.7 device achieves high spin Hall conductivity with thermal robustness, highlighting its potential for energy‐efficient magnetic memory and automotive ...
Han Seok Ko +7 more
wiley +1 more source
Bismuth‐Based Photocatalysts for Water Remediation: Design Strategies, Mechanisms, and Challenges
This review highlights representative design strategies for bismuth‐based semiconductor photocatalysts in solar‐driven water purification. Emphasis is placed on electronic structure regulation, oxygen‐vacancy engineering, and interfacial coupling to enable efficient full‐spectrum light utilization, improved charge separation, and selective oxidation in
Shan Liu +9 more
wiley +1 more source
Oligomerizing Pluronic triblock copolymers provides a processing strategy for tuning the mechanical properties and stimuli‐responsive behaviors of micellar hydrogels. Varying oligomer fraction produces hydrogels spanning brittle to highly extensible responses; maintaining micellar architectures enables cooling‐induced reverse thermal shape memory and ...
Gourav Kumbhojkar +8 more
wiley +1 more source
Optimization Design for Vibration Reduction of Polyurethane–Rubber Composite Damping Material
Stand-off free layer damping is a vibration reduction treatment established on the traditional free layer damping structure. Based on the theory of stand-off free layer damping, polyurethane-rubber stand-off layer damping material was prepared by using ...
Longqiang LIANG +4 more
doaj
Spin Dynamics in the van der Waals Ferromagnet CrTe2 Engineered by Niobium Doping
Spin‐dynamic magnetic properties of van der Waals (vdW) ferromagnet 1T‐CrTe2 are tuned via niobium (Nb) as Cr1‐xNbxTe2 (x = 0–0.2). Nb doping enables wide‐band tuning of the resonance frequency from 40 GHz down to the few‐GHz regime, accompanied by a moderate increase in the Gilbert damping from ∼0.066 to ∼0.14.
Dhan Raj Lawati +16 more
wiley +1 more source
Research in the important parameters for modeling the dynamic behavior of soils has led to rapid development of the small strain stiffness and damping ratio for use in the seismic method. It is because, the experimental determination of the damping ratio
Bawadi Nor Faizah +3 more
doaj +1 more source

