Wearable Biosensor Standardization: How to Make Them Smarter
Standards, 2022 The availability of low-cost plug-and-play devices may contribute to the diffusion of methods and technologies for the personalized monitoring of physiological parameters by wearable devices.
Giada Giorgi, Sarah Tonello
doaj +1 more source
A single-step protocol for closing experimental atom balances
MethodsX, 2020 Molar balances are considered to be closed if they are within 95–105%. It was shown in the companion paper “https://doi.org/10.1016/j.cej.2018.12.113; Chem. Eng.
Philippe M. Heynderickx
doaj +1 more source
Correction to: Korea hypertension fact sheet 2020: analysis of nationwide population-based data
Clinical Hypertension, 2021 An amendment to this paper has been published and can be accessed via the original article.
Hyeon Chang Kim +6 more
doaj +1 more source
NIMS fatigue data sheet on gigacycle fatigue properties of A2017 (Al-4.0Cu-0.6Mg) aluminium alloy
Science and Technology of Advanced Materials: MethodsThe new fatigue data sheets, Nos. 135 and 136, disclose the gigacycle fatigue properties of A2017-T4 aluminium alloys. No. 135 shows gigacycle fatigue test results at a stress ratio of R = −1 up to 1010 cycles, obtained by rotating bending fatigue ...
Yoshiyuki Furuya +2 more
doaj +1 more source
Characterising the ice sheet surface in Northeast Greenland using Sentinel-1 SAR data
Journal of Glaciology, 2023 Over half of the recent mass loss from the Greenland ice sheet, and its associated contribution to global sea level rise, can be attributed to increased surface meltwater runoff, with the remainder a result of dynamical processes such as calving and ice ...
Qingying Shu +6 more
doaj +1 more source
NIMS fatigue data sheet on low- and high-cycle fatigue properties of boron steel
Science and Technology of Advanced Materials: MethodsThe new fatigue data sheet, No. 134, discloses the low- and high-cycle fatigue properties of boron steel. The low-cycle fatigue tests under strain-controlled conditions used incremental step tests to show cyclic stress-strain curves and constant-strain ...
Yoshiyuki Furuya +2 more
doaj +1 more source
A Generative AI–Based Technical Data Extraction Tool for IoT Application Systems
SensorsNowadays, Internet of Things (IoT) application systems play an essential role in smart cities, industry, healthcare, agriculture, and smart homes. For non-expert users, designing and implementing IoT application systems remains challenging, especially ...
Dezheng Kong +5 more
doaj +1 more source
Incidence Angle Normalization of Dual-Polarized Sentinel-1 Backscatter Data on Greenland Ice Sheet
Remote Sensing, 2022 The backscatter coefficients of Synthetic Aperture Radar (SAR) images that observe the Greenland Ice Sheet (GrIS) are incidence angle dependent, which impedes subsequent applications, such as monitoring its surface melting.
Xiao Chen +4 more
doaj +1 more source
Statistical Modeling for Nanofluid Flow: A Stretching Sheet with Thermophysical Property Data
Colloids and Interfaces, 2020 This paper reports the use of a numerical solution of nanofluid flow. The boundary layer flow over a stretching sheet in combination of two nanofluids models is studied.
Alias Jedi +8 more
doaj +1 more source
Creep data sheet for Nickel-based 19Cr-18Fe-3Mo-5Nb-Ti-Al superalloy
Science and Technology of Advanced Materials: MethodsCreep data of Ni-based 19Cr-18Fe-3Mo-5Nb-Ti-Al superalloy (JIS NCF718-B) were obtained at 550°C to 750°C under 100MPa to 1000MPa and analyzed to determine the 100,000 h creep rupture strength.
Kota Sawada +5 more
doaj +1 more source