Results 31 to 40 of about 141 (125)

A family of Z‐source‐based half‐bridge inverters: Topology derivation

IET Power Electronics
Z‐source‐based half‐bridge inverters are a type of Z‐source inverters whose outer stage is a half‐bridge inverter. This paper presents a generalized structure from which 16 configurations can be derived. Once this topology has been introduced, one of the
Mohmmadamin Aalami, Ebrahim Babaei, Saied Ghassem Zadeh   +2 more
doaj   +1 more source

A new family of boost active neutral point clamped inverter topology with reduced switch count

IET Power Electronics, 2021
A new family of inverter topology for active neutral point clamped (ANPC) is proposed. The traditional ANPC gives the output voltage of half the input voltage which necessitates the use of higher input dc‐link voltage.
Marif Daula Siddique, B. Prathap Reddy, Atif Iqbal, Saad Mekhilef   +3 more
doaj   +1 more source

Large‐Scale Growth of Self‐Poled Ferroelectric Rashba Semiconductor α‐GeTe(111) Thin Films: A Crucial Step Towards Future CMOS‐Compatible Ferroelectric Spintronic Devices

Advanced Science, EarlyView.
Ferroelectric Rashba semiconductors promise ultralow‐power devices but lack industry‐quality films. This work demonstrates CMOS‐compatible fabrication of high‐quality α‐GeTe(111) films via magnetron sputtering, enabled by a 5 nm Sb2Te3 seed layer. Structural and ferroelectric analyses show robust, switchable polarization comparable to MBE films, paving
Jules Lagrave, Nicolas Bernier, Thomas Jalabert, Yoann Brûlé, Damien Térébénec, Pierre Meilleur, Hervé Roussel, Jean‐Baptiste Dory, Oussama J. Mouawad, Thibault Chommaux, Cristian Mocuta, Dominique Thiaudière, Laurent Vila, Françoise Hippert, Pierre Noé   +14 more
wiley   +1 more source

New multilevel inverter based on reduced switch basic cell for high voltage levels

IET Power Electronics
In this study, to solve total harmonic distortion (THD) and voltage stress on switches, challenges have been made by presenting a new multi‐level inverter (MLI). The proposed topology can operate with both symmetric and asymmetric sources.
Ali Seifi, Seyed Hossein Hosseini, Mehrdad Tarafdar Hagh, Majid Hosseinpour   +3 more
doaj   +1 more source

Overcurrent protection based on ANNs for smart distribution networks with grid‐connected VSIs

IET Generation, Transmission & Distribution, 2021
Recently, the global concern for protection coordination is growing with the impact of distributed generators connected to medium voltage distribution system.
Mostafa Bakkar, S. Bogarra, F. Córcoles, J. Iglesias   +3 more
doaj   +1 more source

Neuromorphic Near‐Sensor and In‐Sensor Computing Enabled by Next‐Generation Material‐Based Sensors

Advanced Science, EarlyView.
This Review presents a structural framework that classifies neuromorphic sensing into near‐sensor and in‐sensor architectures, clarifying physical coupling between sensing and computation. The framework connects neural and synaptic device functions with recent advances in optical, mechanical, and chemical sensing, compares energy consumption and ...
Su Yeon Jung, Gwang Ya Kim, Sejin Kim, Hyunjong Seo, Se Gi Lee, Sang Min Won, Dongjoon Rhee, Joohoon Kang   +7 more
wiley   +1 more source

A novel nine‐level inverter, applicable in air plane ground power unit

IET Power Electronics
In this study, a novel nine‐level inverter using one voltage source, 10 unidirectional and one bidirectional power switches, and two capacitors has been proposed to utilize in ground power units (GPUs).
Reza Ebrahimi, Hossein Madadi Kojabadi
doaj   +1 more source

RPWM selective voltage harmonic elimination method for single‐phase five‐level MPUC inverter based on cell division

IET Generation, Transmission & Distribution, 2021
The conventional selective harmonic elimination method of random pulse width modulation (RPWM) is only suitable for the two‐level inverter. Furthermore, when the harmonics below 6 kHz are selectively eliminated, it is easy to cause a low average ...
Guohua Li, Dongman Cao, Yufeng Wang
doaj   +1 more source

Multiferroic‐Centric Materials and Systems Engineering for Battery Applications: An Insight Into Mechanisms, Strategies, and Characterizations

Advanced Science, EarlyView.
Multiferroic order parameters – polarization, magnetization, and ferroelastic strain – are positioned as dynamic design variables for batteries. Their mechanistic roles, practical tuning through fabrication and external fields, and ferroic‐resolved characterization routes are unified into a closed‐loop framework, revealing how coupled ferroic responses
Jiaqi Su, Yanda Zhu, Hao Peng, Manman Li, Xuzihan Zhang, Meixiao Wu, Siyuan Zhang, Yuhan Zeng, Jiwen Liao, Ming Luo, Hetaishan Huang, Yutong Wang, Sean Li, Wenxian Li   +13 more
wiley   +1 more source

Impact of Parasitics on the Dynamic Performance of Capacitor Clamped Bidirectional DC–DC Converter

IET Power Electronics
This study investigates the impact of parasitic elements on the dynamic performance of a capacitor clamped bidirectional DC–DC converter (CC‐BDC) to emulate real‐world conditions. Non‐ideal factors, including component imperfections and parasitic losses,
Dogga Raveendhra, Komma Lavanya, Kalamchety Srinivasa Ravi Kumar, Vijay Babu Koreboina, Janaki Pakalapati, Yatindra Gopal   +5 more
doaj   +1 more source