Results 31 to 40 of about 3,565 (314)
Analysis and design of synchronous‐rectified LLC DC–DC converter for LDC of electric vehicles
In electric vehicles (EVs), the low voltage dc‐dc converter (LDC) with synchronous rectifier switches (SRs) can be used to reduce conduction loss caused by the high load current and improve the efficiency.
Xiang Zhou +3 more
doaj +1 more source
Synchrotron Radiation for Quantum Technology
Materials and interfaces underpin quantum technologies, with synchrotron and FEL methods key to understanding and optimizing them. Advances span superconducting and semiconducting qubits, 2D materials, and topological systems, where strain, defects, and interfaces govern performance.
Oliver Rader +10 more
wiley +1 more source
Silicon carbide MOSFETs have current ratings that are not sufficiently high to be used in high‐power converters. It is necessary to connect several MOSFETs in parallel in order to increase current capabilities.
Adel Rezaeian +2 more
doaj +1 more source
By a simple anti‐Galvanic reaction, up to six copper atoms could be preferably doped into the Ag2(SR)5 staple motifs and Ag20 dodecahedral shell of an atomically precise Ag44(SR)30 nanocluster. When anatase TiO2 is used as substrate, the (AgCu)44/TiO2 photocatalyst exhibited much improved activity in photocatalytic CO2 reduction compared to Ag44/TiO2 ...
Ye Liu +5 more
wiley +1 more source
Stirling Convertor Controller Development at NASA Glenn Research Center [PDF]
For nearly two decades, NASA Glenn Research Center (GRC) has been supporting the development of Radioisotope Power Systems (RPS). NASA desires higher conversion efficiency RPS options that are reliable and robust with long life design. Dynamic conversion,
Dugala, Gina M.
core +4 more sources
Distributed online active balancing scheme for battery energy storage system
Focussing on the ineffective operating cycle and potential battery life degradation introduced by traditional energy converter‐based balancing techniques, a new distributed online active balancing scheme is proposed.
Pu Liu +5 more
doaj +1 more source
Electric control of magnetic tunnel junctions offers a path to drastically reduce the energy requirements of the device. Electric field control of magnetization can be realized in a multitude of ways. These mechanisms can be integrated into existing spintronic devices to further reduce the operational energy.
Will Echtenkamp +7 more
wiley +1 more source
The chemical composition and band alignment are systematically investigated at the TiO2/InP heterointerface. Thin TiO2 films are deposited by ALD on atomically ordered, P‐terminated p‐InP(100). By combining UPS, XPS, and ab initio molecular dynamics, the atomistic structure and electronic alignment are revealed.
Mohammad Amin Zare Pour +11 more
wiley +1 more source
Soft‐Switched Non‐Isolated Double‐Input High Step‐Up Converter With Low Input Current Ripple
This paper proposed a novel high step‐up converter with a dual‐input, single‐output DC–DC converter configuration. The design achieves a high conversion ratio while reducing voltage stress on switching devices and enhancing overall efficiency. The design
Hayder Ameer Hasan Al‐Ameedee +3 more
doaj +1 more source
Permanent magnet synchronous generators (PMSGs) equipped with back‐to‐back grid‐forming converters have the ability to form a 100% renewable energy power grid.
Jianhui Meng +4 more
doaj +1 more source

