Results 31 to 40 of about 3,017 (267)
Significant nanoscale oxygen diffusion coefficient variations are measured in ferroelectric hafnium zirconium oxide films with grain boundaries and electrode interfaces exhibiting values 104 times larger than the grain cores. Overall coefficients are 10X larger for films prepared with metal nitride electrodes compared to refractory metals. New insights
Liron Shvilberg +6 more
wiley +1 more source
Centralized DC voltage control for a Multiport converter in distribution grids
Power electronics components are becoming essential for smart grids, especially integrating systems such as renewable energies, storage or electric vehicles.
Martí Domínguez-Hernàndez +3 more
doaj +1 more source
Passive Fault-Tolerant Control Strategies for Power Converter in a Hybrid Microgrid
Control of AC/DC pulse-width modulation (PWM) power electronic converter, referred to as “AC/DC PWM converter”, is vital to the efficient regulation of power flow between AC and DC parts of a hybrid microgrid.
Saeedreza Jadidi +2 more
doaj +1 more source
Efficient simulation of DC‐AC power converters using multirate partial differential equations [PDF]
AbstractSwitch‐mode power converters are used in various applications to convert between different voltage (or current) levels. They use transistors to switch on and off the input voltage to generate a pulsed voltage whose arithmetic average is the desired output voltage of the converter.
Andreas Pels +2 more
openaire +2 more sources
A printed superparamagnetic nanoparticle‐based flux guide enables the realization of a hysteresis‐free three‐axis magnetic sensor. This innovative architecture efficiently redirects out‐of‐plane fields to planar sensing elements, facilitating simultaneous vector detection without complex reset protocols.
Changyeop Jeon +10 more
wiley +1 more source
Evaluation of Feasible Interlinking Converters in a Bipolar Hybrid Microgrid
A bipolar hybrid microgrid is a new topology which benefits from the advantages of both alternating current (AC) and direct current (DC) microgrids. Interlinking AC/DC converter is the key of this topology which has the following characteristics: being ...
Parviz Najafi +2 more
doaj +1 more source
Due to the intermittent nature of the renewable energy systems (RESs), more specifically, solar panels and wind turbines, their sole use does not lead to a smooth and reliable power. To overcome this issue, the concurrent grid‐integration of RESs to form
Hamed Bizhani +5 more
doaj +1 more source
Integration of Voltage Source Converters in Steady-State RMS Short-Circuit Analysis
Voltage source converters (VSCs) are self-commutated converters able to generate AC voltages with or without the support of an AC connecting grid. VSCs allow fast control of active and reactive powers in an independent way.
Carlos Coelho Teixeira, Helder Leite
doaj +1 more source
Ultrawide Bandwidth Optomechanical Magnetometry Using Flux Concentration
High‐permeability flux concentrators enable ultrawide‐bandwidth chip‐scale optomechanical magnetometry by exploiting magnetic nonlinearity to up‐convert low‐frequency fields to the mechanical resonance, where sensitivity is optimal. This enables flat wideband operation over more than four orders of magnitude, from tens of kilohertz to sub‐hertz ...
Benjamin J. Carey +6 more
wiley +1 more source
Design of an inductor-less step-up ac/dc converter for 0.3 V@1 MHz vibration energy harvesting
For vibration energy harvesting, we propose an inductor-less step-up ac/dc converter in this paper. To realize the inductor-less design, the proposed ac/dc converter consists of two converter blocks: Cockcroft–Walton circuit and charge pump.
Kei Eguchi +3 more
doaj +1 more source

