High Efficiency Cross-Coupled Charge Pump Circuit with Four-Clock Signals [PDF]
© Allerton Press, Inc. 2018A fully integrated cross-coupled charge pump circuit for boosting dc-to-dc converter applications with four-clock signals has been proposed. With the new clock scheme, this charge pump eliminates all of the reversion power loss
Cai, Xinglong +3 more
core +2 more sources
In Situ Study of Resistive Switching in a Nitride‐Based Memristive Device
In situ TEM biasing experiment demonstrates the volatile I‐V characteristic of MIM lamella device. In situ STEM‐EELS Ti L2/L3 ratio maps provide direct evidence of the oxygen vacancies migrations under positive/negative electrical bias, which is critical for revealing the RS mechanism for the MIM lamella device.
Di Zhang +19 more
wiley +1 more source
Three new DC-to-DC Single-Switch Converters
This paper presents a new family of three previously unidentified dc-to-dc converters, buck, boost, and buck-boost voltage-transfer-function topologies, which offer advantageous transformer coupling features and low capacitor dc voltage stressing.
Barry W. Williams, Mona Fouad Moussa
doaj +1 more source
Radiated microwave power transmission system efficiency measurements [PDF]
The measured and calculated results from determining the operating efficiencies of a laboratory version of a system for transporting electric power from one point to another via a wireless free space radiated microwave beam are reported.
Brown, W. C., Dickinson, R. M.
core +1 more source
DDPWM-based power conversion system using three to four phase matrix converter for stand-alone power system [PDF]
This paper presents a novel stand-alone power system using a three to four phase matrix converter (MC) for use with renewable energy sources such as a micro hydro turbine or a tiny wind turbine with a permanent magnet synchronous generator (PMSG).
Hanamoto, Tsuyoshi +2 more
core +1 more source
Series SEPIC implementing voltage-lift technique for DC–DC power conversion
The voltage-lift technique is an effective method that could be applied in electronic circuit design. A set of positive output DC-DC converters applying series SEPIC implementing voltage-lift techniques is introduced. Compared with the prototype of the SEPIC converter, these converters can perform positive to positive DC-DC voltage increasing ...
M. Zhu, F.L. Luo
openaire +1 more source
Spectrally Tunable 2D Material‐Based Infrared Photodetectors for Intelligent Optoelectronics
Intelligent optoelectronics through spectral engineering of 2D material‐based infrared photodetectors. Abstract The evolution of intelligent optoelectronic systems is driven by artificial intelligence (AI). However, their practical realization hinges on the ability to dynamically capture and process optical signals across a broad infrared (IR) spectrum.
Junheon Ha +18 more
wiley +1 more source
Design and development of fly-back converter with buck-boost regulator for DC motor used in electric vehicle for the application of renewable energy [PDF]
This paper presents design and development of fly-back converter with buck-boost regulator for dc motor used in electric vehicle for renewable energy application. An electric vehicle working with DC motor energized from fly-back converter with buck-boost
Manjesh, ., Manjunatha, K.C.
core +1 more source
Advanced control methods and topologies for DC-DC power conversion [PDF]
The investigation in this thesis begins with modeling and control of high-order DC-DC converters. Generalized state-space modeling, especially reduced-order state-space modeling method, is used to design suitable controllers for advanced DC-DC converters. An improved Sliding Mode (SM) controller is proposed for advanced DC-DC converters.
openaire +2 more sources
The DC Inductor Current Ripple Reduction Method for a Two-Stage Power Conversion System [PDF]
Hyeong-Jin Kim +5 more
openalex +1 more source

