Results 131 to 140 of about 5,173 (291)
Advanced Materials Interfaces, EarlyView.Simplified quantum sensing technique for the detection of short electrical signals occurring in neuronal signaling or bioinspired technologies. We demonstrate a single frequency continuous‐wave optically detected magnetic resonance (CW‐ODMR) approach to sense signals that can be as short as 0.2 ms.
João Paulo Silva +4 more
wiley +1 more source
Analysis of the voltage source inverter with small DC-link capacitor [PDF]
, 2005 IIn electric drives, frequency converters are used to generatefor the electric motor the AC voltage with variable frequency and amplitude. When considering the annual sale of drives in values of money and units sold, the use of low-performance drives ...
Sarén, Hannu
core
Light Switchable Ionic Conductivity of Arylazopyrazole Modified Polysiloxanes
Advanced Materials Technologies, EarlyView.We present a polysiloxane functionalized with a novel arylazopyrazole dye that undergoes reversible photoisomerization. Upon lithium bis(trifluoromethanesulfonyl)imide addition and UV irradiation, the polymer exhibits a shift in tan(d) toward higher frequencies and enhanced ionic conductivity.
Malte S. Beccard +7 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.This review explores advances in wearable and lab‐on‐chip technologies for breast cancer detection. Covering tactile, thermal, ultrasound, microwave, electrical impedance tomography, electrochemical, microelectromechanical, and optical systems, it highlights innovations in flexible electronics, nanomaterials, and machine learning.
Neshika Wijewardhane +4 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.A MEMS‐integrated metamaterial filter enables continuous, low‐voltage spectral tuning in the long‐wavelength infrared (LWIR). The device employs extraordinary optical transmission in a dual suspended metasurface stack, where electrostatic actuation precisely controls the intermembrane air gap.
Oleg Bannik +6 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.We introduce an additively manufactured bioreactor with a perfusion flow system and integrated temperature and pH sensors for skeletal muscle tissue biofabrication. The bioreactor's performance was evaluated by assessing the viability, spreading of the myoblast cells in a printed scaffold, and contraction of the isolated murine musculi interossei ...
Lys Sprenger +9 more
wiley +1 more source
Skin‐Like Tri‐Modal Sensors Based on Soft Piezoelectric and Ionic Composites
Advanced Materials Technologies, EarlyView.Inspired by the multimodal perception of human skin, a soft, skin‐like tri‐modal sensor is presented. The device incorporates an ionically conductive, piezoelectric, elastic composite as its active layer, enabling independent detection of temperature, static strain, and dynamic strain within a single two‐terminal architecture.
Liren Wang +9 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.An AlON interfacial layer is engineered within an AlN switching layer to enable transparent RRAM with four stable resistance states. The device achieves low‐voltage multilevel switching and a high HRS, allowing precise grayscale modulation and preventing light leakage in micro‐LEDs operated at VDD = 2.7 V.
Sung Keun Choi +7 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.A flexible pressure sensor utilizing a 3D dual‐pore polyurethane structure is developed to overcome the intrinsic trade‐off between sensitivity and linearity. By inducing sequential buckling through distinct pore sizes and shapes, the device achieves highly linear and sensitive responses across a wide pressure range.
Jae Yeong Jang, Jaemin Choi, Young Jung
wiley +1 more source
Single-phase to three-phase DC-link boost converter with reduced controlled switch count. [PDF]
Sci RepNagi HA, El-Sabbe AE, Osheba DSM.
europepmc +1 more source