Results 51 to 60 of about 6,632,080 (294)
It is a common practice that one converter controls DC voltage and the other controls power in two-terminal voltage source converter (VSC)−based high voltage DC (HVDC) systems for AC gird interconnection.
Yuye Li +4 more
doaj +1 more source
The dual active bridge (DAB) DC–DC converter is typical in DC transformers to realize the voltage transformation and power transmission, which is determined by modulation. However, in traditional phase shift modulation strategies, the zero-voltage-switch
Yiting Xiao, Yuanpeng Guan, Li Qin
doaj +1 more source
Fabrication Routes for Ionic Conducting Fiber Strain Sensors
Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw +3 more
wiley +1 more source
Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Due to galvanic isolation, bidirectional power transmission and extensive voltage adjustment, dual active bridge (DAB) exerts significant interface between renewable sources and electric vehicle (EV) storage port. However, for DAB operations, under light
Jiachen Tian +4 more
doaj +1 more source
Control of Polarization and Polar Helicity in BiFeO3 by Epitaxial Strain and Interfacial Chemistry
In BiFeO3 thin films, the interplay of interfacial chemistry, electrostatics, and epitaxial strain is engineered to stabilize homohelicity in polarization textures at the domain scale. The synergistic use of a Bi2O2‐terminated Aurivillius buffer layer and a highly anisotropic compressive epitaxial strain offers new routes to control the polar‐texture ...
Elzbieta Gradauskaite +5 more
wiley +1 more source
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa +19 more
wiley +1 more source
A novel bidirectional DC-DC converter
For shortages of traditional Buck-Boost converters such as limited output voltage, poor stability, low voltage gain and so on, a novel bidirectional DC-DC converter was designed which used Z-source network to connect DC input power and load.
FANG Xupeng, ZHUANG Jianwei, LI Hui
doaj +1 more source
Consideration on the Economy for Superconducting DC Power Transmission
Recently, resistive-cryogenic dc cable system or superconducting dc cable system is actively investigated as the underground cable transmission at each country. It is a very interesting problem to compare the each cable system from viewpoints of techniques and economics.We have done the economical comparison of conventional dc cable system, the ...
IHARA, Seijiro, HORIGOME, Takashi
openaire +2 more sources
Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee +16 more
wiley +1 more source

