Results 91 to 100 of about 1,378,548 (286)
Anode‐free lithium metal batteries (AFLMBs) are now considered as a promising next‐generation energy storage system due to their exceptional energy density and compatibility with existing lithium‐ion battery manufacturing infrastructure.
Maolin Sun, Kai Tang, Zhichuan J. Xu
doaj +1 more source
Out‐of‐Plane Strain‐Decoupled Architecture for High‐Fill‐Factor Stretchable OLED Displays
A vertically decoupled multilayer SOLED architecture separates emissive pixel islands from deformable interconnects, allowing low‐modulus elastomeric layers to accommodate applied strain and suppress strain transfer to the OLED region. This design, combined with transparent hybrid encapsulation, enables a high fill factor (∼75%), stretchability ...
Young Hyun Son +2 more
wiley +1 more source
This work reveals the influence of polymer side‐chain electronic effects on the Li+ solvation sheath in gel polymer electrolytes. Electron‐donating side chains induce the strong Li+ coordination and FDMA‐dominated solvation, impeding Li+ desolvation, whereas electron‐withdrawing side chains weaken Li+ coordination, facilitating anion‐rich solvation and
Xianbin Wu +7 more
wiley +1 more source
Thermophysical Properties of Lithium Bromide + 1, 2-Propanediol Aqueous Solutions— Solubility, Density and Viscosity [PDF]
The solubilities, densities and viscosities of lithium bromide (LiBr) + 1, 2-propanediol (HO-CH2-CHOH-CH3) aqueous solution (mass ratio of LiBr/HO-CH2-CHOH-CH3 = 3.5, 4.5 and 5.5) were measured in the mass fraction range from 0.30 to 0.75.
Vineyard, Edward A. +2 more
core +1 more source
We propose and demonstrate a novel method for the elimination of arbitrary frequency chirp from short optical pulses. The technique is based on the combination of two cascaded second-order nonlinearities in two individual periodically poled lithium ...
Lee, Kwang Jo +10 more
core +1 more source
Lithium-ion-conducting membrane for selective lithium extraction
This thesis establishes a simple method called sol-gel dip coating for the fabrication of lithium selective ceramic thin membranes supported on a porous substrate.
Umma Habiba (10845431)
core +1 more source
Defect‐free transfer principles enable scalable fabrication of 15 µm‐thin garnet‐based hybrid solid electrolytes. Hansen solubility parameters correlate interfacial compatibility with coating, transfer, and impregnation behavior, guiding rational selection of slurry/substrate, binder/substrate, and binder/polymer electrolyte combinations.
Seul Gi Chu +8 more
wiley +1 more source
Proton-exchanged lithium niobate waveguides for photonic applications
This talk shall provide an overview of the current activity on integrated LiNbO3 devices based on proton-exchange techniques at the ORC. We shall present the technology and the experimental results obtained so far on slab waveguides in 2D Nonlinear ...
Gallo, Katia +3 more
core +1 more source
Description: Indium metal serves as a reversible calcium‐alloying negative electrode. By transitioning from planar electrodes to powders and (sub‐)micron indium particles, the specific surface area is increased, improving the areal capacity density and cycling stability for calcium‐based batteries.
Wouter Monnens +10 more
wiley +1 more source
A spatial location of atomic layer deposition (ALD)‐derived ZrO2 coatings is demonstrated to be a critical design parameter for stabilizing graphite cathodes in DIBs. Direct particle‐level ALD (PALD) screening of representative metal oxides identified ZrO2 as the coating that provides the most favorable balance of high‐rate capability and interfacial ...
Jieun Kang +7 more
wiley +1 more source

