Results 121 to 130 of about 4,767,291 (342)
Experimental Study and Calculation Methods of Shear Capacity for High-Strength Reinforced Concrete Full-Scale Deep Beams. [PDF]
Materials (Basel), 2022 Li S, Wu Z, Zhang J, Xie W.
europepmc +1 more source
CVII. On the buckling of deep beams [PDF]
The London, Edinburgh, and Dublin Philosophical Magazine and Journal of Science, 1922 n ...
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink +4 more
wiley +1 more source
Cracking and Fiber Debonding Identification of Concrete Deep Beams Reinforced with C-FRP Ropes against Shear Using a Real-Time Monitoring System. [PDF]
Polymers (Basel), 2023 Papadopoulos NA +3 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal +3 more
wiley +1 more source
Reinforced concrete deep beams : behaviour, analysis and design [PDF]
, 1987 PhD ThesisThe work described in this thesis is concerned with the behaviour, analysis and design of reinforced concrete beams. A brief historical review of the methods of analysis on deep beams is given.
Tang, Chi Wai John
core
Advanced Engineering Materials, EarlyView.This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome +6 more
wiley +1 more source
Application of Plasticity Theory to Reinforced Concrete Deep Beams
, 2008 YesThis paper reviews the application of the plasticity theory to reinforced concrete deep beams. Both the truss analogy and mechanism approach were employed to predict the capacity of reinforced concrete deep beams.
Yang, Keun-Hyeok, Ashour, Ashraf
core +1 more source
Active Corrosion Protection of Sintered AA7075 Aluminum Alloy via Mn Powder Addition
Advanced Engineering Materials, EarlyView.AA7075 containing Mn‐rich particles is fabricated via spark plasma sintering using AA7075 and Mn powders. Corrosion resistance is evaluated through dip‐and‐dry tests using 0.1 M NaCl (pH 6.0), and mass loss decreases with increasing Mn addition. Mn‐rich particles function as a source of Mn ions, and formation of Mn‐accumulation films on Cu‐containing ...
Ko Ebina, Masashi Nishimoto, Izumi Muto
wiley +1 more source
Behaviour of reinforced concrete deep beams
, 2016 Twenty five model beams were progressively loaded to failure in order to investigate the influence of the following variables on the behaviour of reinforced concrete deep beams : i) Concrete compressive strength ii) Reinforcement iii) Geometry. The model
Green, Jeremy Robert
core +1 more source