Results 51 to 60 of about 6,426 (198)
The high temperature and high in-situ stress geological environment can significantly affect the mechanical properties, failure modes, and deformation characteristics of deep shale reservoirs.
Wuhao Guo +7 more
doaj +1 more source
This study demonstrates the feasibility of an underground closed‐loop thermal storage facility at a post‐mining site, intended for seasonal heat energy storage. Its principal design shows water flow directions in winter and summer (1, 2), heat pumps (3), an upper water reservoir (4), and connecting pipes (5).
Dmytro Rudakov, Oleksandr Inkin
wiley +1 more source
Fault slip can occur ahead of the injection pressure front due to poroelastic stress. Our model captures the interaction of pressure, stress, and friction, providing new insights into injection‐induced seismicity and post‐injection fault slip. Shut‐in operations can either mitigate or accelerate seismic events depending on fault conditions and ...
Qifeng Xie, Lei Wang, Qi Li
wiley +1 more source
The classification of shale lithofacies, pore structure characteristics, and controlling factors of gas enrichment in deep-marine shale are critical for deep shale gas exploration and development.
Liyu Fang +5 more
doaj +1 more source
The deep shale gas reservoirs of Upper Ordovician Wufeng–Lower Silurian Longmaxi Formation in the Dingshan area of the southeastern Sichuan Basin have a great burial depth and complicated geologic features, so the fracturing technologies that are used ...
Hua Duan +4 more
doaj +1 more source
This study establishes a multi‐factor coupling framework for predicting breakdown pressure in laminated shale by integrating experimental hydraulic fracturing tests, physics‐informed neural networks (PINNs), and Sobol sensitivity analysis. It reveals how differential stress, the bedding dip angle, and the injection rate interact to influence fracture ...
Tao Wang +6 more
wiley +1 more source
This study assesses whether a saline aquifer in the German North Sea can sustain industrial‐scale CO2 injection at 10 Mt/year over 30 years. A 3D reservoir model is used to compare static capacity with dynamically achievable storage. The work links site‐scale injection strategy design with basin‐scale pressure response, providing a framework for ...
Firdovsi Gasanzade, Sebastian Bauer
wiley +1 more source
Well XA‐1, completed at a true vertical depth of 11 156 m in the Shawan Sag of the Junggar Basin, is the deepest predominantly near‐vertical well drilled in a sedimentary basin. The figure shows the basin's tectonic framework and well location (a), a structural cross‐section spanning the Shawan Sag and adjacent uplifts (b), and the stratigraphic column
Fangkai Liu +3 more
wiley +1 more source
Deep shale gas(buried depth>3 500 m) is the potential resource for future exploration in Sichuan Basin.Although the industrial shale gas flows have been obtained at the depth of 3 500~4 000 m in Wufeng-Longmaxi Formation of Sichuan Basin,the commercial ...
HE Zhiliang, NIE Haikuan, JIANG Tingxue
doaj
Compared with the middle-shallow shale gas reservoirs, deep shale formation often reveals lower fracture complexity, smaller effective stimulated volumes, lower conductivity, and faster declined when the same injection model and technical parameters were
Xin Chang
doaj +1 more source

