Results 231 to 240 of about 10,020,504 (351)
The present study investigates recycling of NiTi shape memory alloys via vacuum induction melting. An ingot was synthesized from elemental Ni and Ti and subjected to three subsequent remelting cycles. Remelting increases process durations and impurity levels and adversely affects microstructures and functional properties.
Sakia Sophia Noorzayee +7 more
wiley +1 more source
Spatiotemporal Dynamics of Fish Density in a Deep-Water Reservoir: Hydroacoustic Assessment of Aggregation Patterns and Key Drivers. [PDF]
Meng Z, Hu F, Xiang M, Fu X, Li X.
europepmc +1 more source
Hawaii Deep Water Cable Program, phase II-D task 5 : Revised basic design criteria data book
George Krasnick, J. Mansur
openalex +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Ultrasound-Assisted Extraction (UAE) for the Utilization of Deep-Water Pink Shrimp (Parapenaeus longirostris) Processing Waste: Comprehensive Characterization of Carotenoid Astaxanthin Rich Extract. [PDF]
Dikel Ç, Yanar Y.
europepmc +1 more source
Interstitial Water Chemistry Deep Sea Drilling Project, Leg 5
B.J. Presley +2 more
openalex +1 more source
Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley +1 more source
Comparison Between Water Aerobics and Deep-Water Running on Middle-Aged Adults' Anthropometric, Hemodynamic and Functional Outcomes. [PDF]
Leonel LDS, Danielevicz A, Delevatti RS.
europepmc +1 more source
Nondestructive Testing of Welded Composite Metal Foams
X‐ray computed tomography (CT) is used to evaluate welded steel–steel composite metal foam (CMF) joints of two density classes. It reports variation in postweld spatial void distribution and correlates it to weld‐induced changes, mechanical performance, and failure within welded CMF panels.
Chinmaya Prerana Inguva +2 more
wiley +1 more source

