Results 71 to 80 of about 308,630 (196)
Research on Grain Size Control of 316 Austenitic Stainless Steel Heavy and Medium Plate Rolling
Teshugang, 2019 The influence of the status of billet steel, rolling compression ratio, deformation rate per pass on grain of 316 austenitic stainless steel medium plate was done in laboratory.
杨相歧, 庄迎, 李吉东, 尹嵬
doaj
Advances in Materials Science and Engineering, 2019 The deformation behavior and microstructural evolution of twin-roll-casting AZ31 Mg alloy sheets were investigated via hot compression tests at 0°, 5°, and 10° from the normal direction.
Qingshan Yang +5 more
doaj +1 more source
Anisotropic Deformation in the Compressions of Single Crystalline Copper Nanoparticles
Crystals, 2018 Atomistic simulations are performed to probe the anisotropic deformation in the compressions of face-centred-cubic metallic nanoparticles. In the elastic regime, the compressive load-depth behaviors can be characterized by the classical Hertzian model or
Jianjun Bian +3 more
doaj +1 more source
Direct imaging of short-range order and its impact on deformation in Ti-6Al. [PDF]
, 2019 Chemical short-range order (SRO) within a nominally single-phase solid solution is known to affect the mechanical properties of alloys. While SRO has been indirectly related to deformation, direct observation of the SRO domain structure, and its effects ...
Asta, Mark +11 more
core
Global deformation on the surface of Venus [PDF]
Large-scale mapping of tectonic structures on Venus shows that there is an organized global distribution to deformation. The structures we emphasize are linear compressive mountain belts, extensional rafted zones, and the small-scale but widely ...
Bilotti, Frank +2 more
core +1 more source
Compression deformation behaviors of sheet metals at various clearances and side forces
MATEC Web of Conferences, 2015 Modeling sheet metal forming operations requires understanding of plastic behaviors of sheet metals along non-proportional strain paths. The plastic behavior under reversed uniaxial loading is of particular interest because of its simplicity of ...
Zhan Mei +3 more
doaj +1 more source
Materials & DesignThis study investigates the deformation behaviour of 42CrMo4 steel at high temperatures and varying strain rates, focusing on the impact of different deformation states (compression vs. shear) on material behaviour.
Muhammad Sajjad +5 more
doaj +1 more source
An evaluation method of reliability indicators of automobile textile materials
MATEC Web of Conferences, 2018 The aim of the study was to develop a method for predicting the reliability indicators of automobile textile materials. The characteristics of material deformation under conditions of cyclic compression have been studied, the parameters and test modes ...
Lisienkova Liubov
doaj +1 more source
AIP AdvancesThis study examines unsaturated, fine-grained moraine soil from a high-plateau airport in the Tibetan region. Laboratory tests were conducted to determine key physical characteristics, including particle size distribution, optimal moisture content ...
Meng Li +5 more
doaj +1 more source
MetalsIn this paper, constant strain rate compression was carried out by means of an MMS-100 thermal/force simulation tester in a temperature range of 790~940 °C, with a strain rate of 0.01–1 s−1 and a compression volume of 60%.
Yucheng Yang +5 more
doaj +1 more source