Results 21 to 30 of about 3,217 (172)
Advanced Science, EarlyView.The ultrathin (2.5 nm) MXene film self‐assembled at liquid interfaces breaks the trade‐off between transparency (82.5 %) and photothermal conversion effect (DT∼25.1°C ± 2.9 °C) under 100 mW cm−2. After encapsulated by a slippery surface with low adhesion, this transparent film can be applied in smart windows, eyewear, and optical sensors to autonomous ...
Xiao Han +6 more
wiley +1 more source
Study on the Segmental Defrosting Performance of Air-source Heat Pumps
Zhileng xuebao, 2023 In this study, a novel defrosting method was developed for an air-source heat pump (ASHP) with a multi-circuit outdoor coil operating in a low-temperature and high-humidity environment.
Huang Tao +6 more
doaj
Body donor programs in Australia and New Zealand: Current status and future opportunities
Anatomical Sciences Education, Volume 18, Issue 3, Page 301-328, March 2025.Abstract Body donation is critical to anatomy study in Australia and New Zealand. Annually, more than 10,000 students, anatomists, researchers, and clinicians access tissue donated by local consented donors through university‐based body donation programs. However, little research has been published about their operations.
Rebekah A. Jenkin, Kevin A. Keay
wiley +1 more source
Carbon Energy, EarlyView.The study designed the nanocellulose‐induced “surface‐locking” strategy to stabilize the interface between MnO2 and a carbon‐based substrate. The dissolution of MnO2 was prominently curbed by imparting C–O–Mn bonding and optimized wettability. Zn–MnO2 batteries were endowed with outstanding cyclic stability and improved capacity.
Meng Zhang +10 more
wiley +1 more source
Zhileng xuebao, 2017 Based on the frosting and defrosting problems of cascade air source heat pumps (CASHPs) during heating operation in the cold area in winter, a novel thermal energy storage CASHP defrosting system with a thermal accumulator is proposed.
Qu Minglu +3 more
doaj
Case Studies in Thermal EngineeringThe migration and redistribution of refrigerant are critical factors that affect the refrigeration system performance. To improve the defrosting and start-up heating performance, it is essential to investigate the transient distribution characteristics ...
Tong Xiong +3 more
doaj +1 more source
Windshield Defrost Simplified CFD Model [PDF]
Production Engineering Archives, 2019 Abstract The windshield defrost system, in general, is a vehicle safety feature. Thus, its restricted by variety of directives. However, the OMEs’ benchmark targets could be even more demanding as the deicing process is in addition also part of passengers comfort.
openaire +3 more sources
Chemie Ingenieur Technik, EarlyView.Thermal defrosting limits desublimator efficiency in freeze‐drying. This review and case study compares thermal versus mechanical regeneration, links frost properties and external heat transfer to energy demand, and summarizes pilot‐scale scraping results enabling single‐unit, continuous lyophilization.
Moritz Krummenacher +3 more
wiley +1 more source
Multi‐Dimensional Conductive Nanocomposites for Flexible Electronics
ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.Multi‐dimensional conductive nanocomposites integrate 0D, 1D, and 2D nanomaterials through spatial structure regulation and interface engineering, achieving “1 + 1 > 2” synergistic effects. By leveraging 0D filling to reduce contact resistance, 1D bridging to construct continuous conductive paths, and 2D supporting to enhance mechanical stability ...
Tianyu Wang +12 more
wiley +1 more source
Experimental Research on Defrosting Process of Cooling Fan with Heat Insulation Defrosting Device
Zhileng xuebao, 2014 In order to reduce the effect of defrosting heat on the cold storage temperature change during defrosting process, a heat insulation defrosting device is additionally provided to the air cooler in the storage, and the experimental study on the defrosting
Shen Jiang +3 more
doaj