Effect of phosphate-bonded investments on titanium reaction layer and crown fit [PDF]
Brazilian Oral Research, 2010 This study analyzed the reaction layer and measured the marginal crown fit of cast titanium applied to different phosphate-bonded investments, prepared under the following conditions (liquid concentration/casting temperature): Rema Exakt (RE) - 100%/237 ...
Sicknan Soares da Rocha +4 more
doaj +5 more sources
Effect of modified investment and casting system on the recasting properties of high-gold alloy [PDF]
Journal of Dental SciencesBackground/purpose: High gold (Au) alloys have many advantages, such as good mechanical properties and stable chemical properties for dental restoration.
Pei-Ling Lai +6 more
doaj +2 more sources
The accuracy of custom-made metal posts manufactured using selective laser sintering versus conventional casting techniques: a laboratory study [PDF]
BMC Research NotesBackground The purpose of this study was to evaluate the efficacy of selective laser sintering (SLS) against the traditional casting method in fabricating customized Co-Cr dental posts, employing 3D coordinate metrology for analysis. Methods A 10 mm post
Ahmad Abdulkareem Alnazzawi +4 more
doaj +2 more sources
A comparative study on investment casting of dental crowns for veterinary dentistry by using ABS patterns with and without wax coating [PDF]
E3S Web of Conferences, 2021 The fused deposition modelling (FDM) assisted investment casting (IC) is one of the commercially established routes for fabrication of biomedical parts requiring high precision.
Pradhan Smruti Ranjan +5 more
doaj +1 more source
A quality assessment of titanium castings produced in an experimental short-heating-cycle investment [PDF]
Materials Research, 2013 The aim of this study was to evaluate the quality of casting produced in an experimental short-term heating-cycle investment. Thus, reaction layer and castability of titanium casting using an experimental spinel-based investment (VR) with short heating ...
Gelson Luis Adabo +4 more
doaj +1 more source
Effect of Wax Burn-Out Heating Temperature on The Compressive Strength of Casting Dental Alloy Investment [PDF]
Al-Rafidain Dental Journal, 2008 Aims: To evaluate the effect of the burn-out heating on the compressive strength of investment materials. Materials and Methods: Three commercial investment materials were used in this study.
Lamia T Rejab
doaj +1 more source
Numerical Simulation and Defect Identification in the Casting of Co-Cr Alloy
Metals, 2022 The development of biomaterials, particularly metallic ones, is one of the focuses of the scientific community, mainly due to an increase of average life expectancy and an improvement of the casted materials combined with better mechanical properties and
Raimundo Silva +8 more
doaj +1 more source
Perimbangan Gypsum Bonded Investment terhadap Penysutan Logam Paduan Emas pada Saat Pengecoran
Journal of Dentistry Indonesia, 2015 Gypsum bonded investment is usually used for dental gold alloys casting procedure. Casting alloys shrink during solidified from melting temperature to room temperature.
Ronnie Rusli
doaj +1 more source
Study of Ceramic Slurries for Investment Casting with Ice Patterns [PDF]
, 2004 Ice patterns generated by rapid freeze prototyping or a molding process can be used to make ceramic investment molds for metal castings. Due to the use of ice, the ceramic slurries must be poured around the pattern and cured at sub-freezing ...
Leu, Ming C., Liu, Qingbin
core +1 more source
Internal adaptation of cast titanium crowns
Journal of Applied Oral Science, 2007 As the adaptation of titanium crowns obtained by Rematitan Plus investment, specific for titanium, is not recognized to be suitable, this study evaluated the effect of the concentration of the specific liquid and the temperature of the mold of ...
Sicknan Soares da Rocha +3 more
doaj +1 more source