Results 251 to 260 of about 12,082 (308)

Screw retained vs. cement retained implant‐supported fixed dental prosthesis

open access: yesPeriodontology 2000, 2016
AbstractA fixed dental prosthesis can be secured to an endosseous implant via cementation (using a provisional or definitive cement) on an implant abutment that is screw retained to the implant or directly in the implant via screw retention. The clinical decision as to which retention system best suits the individual patient depends on several factors.
Julia-Gabriela, Wittneben   +3 more
openaire   +3 more sources

Rescue of an implant-supported fixed complete prosthesis after the failure of an implant: A dental technique

open access: yesThe Journal of Prosthetic Dentistry, 2020
This technique article describes the rescue of an existing implant-supported fixed complete prosthesis after the failure of a supporting implant. To achieve this, a system able to rescue the fixed prosthesis after placement of a new implant was used, and the protocol for performing this procedure is described.
Burak Yilmaz   +2 more
openaire   +4 more sources

Dental Implant Supported Thumb Prosthesis with Friction Fit Retention System

JPO Journal of Prosthetics and Orthotics, 2022
ABSTRACT Introduction An amputated thumb causes aesthetic deficit and functional loss. Reconstruction can be surgical or prosthetic. A small residuum leaves little scope for rehabilitation with suction-retained prosthesis. Prosthetic management requires implant placement or distraction osteogenesis to be successful.
Mahimaa Gupta   +5 more
openaire   +1 more source

Effect of Fiber Reinforcement on the Flexural Strength of the Transitional Implant‐Supported Fixed Dental Prosthesis

Journal of Prosthodontics, 2022
AbstractPurposeThe aim of this in vitro study was to assess the efficacy of fiber reinforcement to enhance flexural strength of the transitional implant‐supported fixed dental prosthesis (TISFDP).Materials and methodsOne hundred and forty denture acrylic resin plates (64 mm × 12 mm × 5 mm) with two 7 mm diameter holes were fabricated using heat ...
Shivani Suvarna   +6 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy