Results 171 to 180 of about 50,734 (274)

Workflow to facilitate complete denture scanning with an intraoral scanner: A technique report

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Scanning a denture with an intraoral scanner is typically more challenging than scanning a dentate arch. This article describes a novel technique for digitally duplicating a complete denture. The workflow involves scanning an existing denture using an intraoral scanner with the addition of specific markers and subsequently constructing a ...
Jiayi Yu   +3 more
wiley   +1 more source

Fracture load and retention of milled interim implant restorations fabricated on three types of abutments and two implant diameters: An in vitro study

open access: yesJournal of Prosthodontics, EarlyView.
ABSTRACT Purpose To evaluate the fracture load and retention of subtractively manufactured interim restorations for single‐unit implants of two diameters, using three interim abutment types: stock abutments, titanium base (Ti‐base) abutments, and pre‐milled polymethyl methacrylate (PMMA) abutments.
Dong‐Hun Lee   +5 more
wiley   +1 more source

Impact of monomer contamination of isopropanol during post‐rinsing on the accuracy of dental models fabricated by vat photopolymerization

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose The aim of this study was to investigate the impact of an increasing level of monomer contamination of isopropanol (isopropyl alcohol [IPA]) during post‐rinsing on the dimensional stability of test samples produced by vat photopolymerization.
Florian Flierl   +5 more
wiley   +1 more source

Bond strength enhancement for additively manufactured zirconia: Micro‐retentive design approach

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose To investigate the effect of digitally designed micro‐retention features on the bond strength of additively manufactured (AM) zirconia copings. Materials and Methods Sixty titanium base abutments (NobelParallel, NobelBiocare), pretreated with 50 µm alumina particles were divided into four groups (n = 15 per group); one group with ...
Rama B. Al‐Rashdan   +5 more
wiley   +1 more source

Influence of different manufacturing materials on the accuracy and fitting of full‐arch restorations using a photogrammetry scanner—In vitro study

open access: yesJournal of Prosthodontics, EarlyView.
Abstract Purpose This study aimed to assess the accuracy of a photogrammetry scanner and evaluate the influence of four different manufacturing materials on the accuracy and fitting of full‐arch restorations made using a photogrammetry scanner. Materials and Methods A cast with six implant abutment analogs was made.
Paulo Sergio Borella   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy