Results 261 to 270 of about 220,381 (299)
Some of the next articles are maybe not open access.

Dentin/Adhesive Interface in Teeth

2012
Clinical studies have demonstrated an alarmingly high failure rate for posterior composite dental restorations. The premature failure of moderate-to-large composite restorations can be traced to a breakdown of the bond at the tooth surface/composite material interface and increased levels of cariogenic bacteria at the perimeter of these materials.
Spencer, Paulette   +8 more
openaire   +2 more sources

Human dentin and the dentin-resin adhesive interface

Acta Materialia, 1998
Dentin, the inner hard tissue of teeth, is a complex hydrated composite and forms the substrate for much of restorative dentistry. Current efforts to improve restorative and preventive dentistry involve the development of effective bonds to this tissue.
S.J. Marshall   +8 more
openaire   +1 more source

[Dentin adhesives].

Den Norske tannlaegeforenings tidende, 1990
Chemical adhesion of resin based restorative materials to dentin using adhesives presents a complex problem due to the different nature of polymeric materials and tooth substance. It is indicated that the problems arise mainly from properties of the filling material, eg polymerization shrinkage.
openaire   +1 more source

[Dentin adhesives. An update].

Minerva stomatologica, 1992
Even if mechanical bonding to enamel utilizing the acid-etch technique has been very successful, adhesion to dentin is still a challenge to researchers and clinicians. Dentin is a vital tissue and differs in composition from enamel: acid-etching does not enhance the bond strength of composite resins to dentin and may elicit a severe pulpal response ...
R, Grandini, C, Novelli, P, Pierleoni
openaire   +1 more source

Adhesion to enamel and dentin.

American journal of dentistry, 1990
The physical and chemical properties of restorative materials and procedures that influence the extent of microleakage at the tooth/restoration interface are discussed. Adhesion to enamel is achieved and microleakage at the enamel/restoration interface has been controlled by acid etching enamel surfaces with orthophosphoric acid. The acid concentration
D H, Retief, F R, Denys
openaire   +1 more source

Advances in dentin adhesion.

Compendium of continuing education in dentistry (Jamesburg, N.J. : 1995), 2004
While bonding to enamel has been a dependable technique, bonding to dentin is still an overwhelming task--dentin is a naturally soaked organic tissue. The enamel bonding agents of the 1960s and 1970s progressively evolved into complex multibottle or universal adhesives in the early 1990s.
Jorge, Perdigão   +2 more
openaire   +1 more source

[Dentin-dentinal adhesive interaction. Calorimetric measurement].

Dental Cadmos, 1990
Among the tests employed to evaluate the bond strength between dentine and dental adhesives (tensile or shear bond strength measurements, marginal leakage measurements) a general accordance on their reliability cannot be found. Calorimetric measurement may be useful in deciding if the adhesion is mechanical or chemical.
E, Angelini, M, Pezzoli, F, Zucchi
openaire   +1 more source

Bond Strength of Universal Adhesives to Dentin: A Systematic Review and Meta-Analysis

Polymers, 2021
Naji Kharouf   +2 more
exaly  

The effects of current dentinal adhesives on the dentinal surface.

Quintessence international (Berlin, Germany : 1985), 1995
The effects of the dentinal surface treatments from six currently available commercial dentinal adhesives are presented. The adhesives are All-Bond 2, etched and unetched, Syntac, Prisma Universal Bond 3, Scotchbond Multipurpose, Tenure Solution, and Adhesive By Choice.
R P, Chappell, P, Spencer, J D, Eick
openaire   +1 more source

Home - About - Disclaimer - Privacy