Evaluation of anxiety in patients undergoing complete denture treatment
The Journal of Indian Prosthodontic Society, 2021 Aim: To evaluate anxiety in patients undergoing complete denture treatment. Settings and Design: The most overlooked factor during complete denture treatment is the patient's anxiety regarding the treatment.
Ankita Kirti Pasad +3 more
doaj +1 more source
Analysis of Abstracts Presented at the Prosthodontic Research Section of IADR General Sessions 2004–2005: Demographics, Publication Rates, and Factors Contributing to Publication [PDF]
, 2011 Purpose: The purposes of this study were to describe the demographics of abstracts presented at the prosthodontics section of IADR General Sessions from 2004 to 2005, evaluate the publication rate of abstracts, and analyze the relationship between ...
Barao, Valentim A. R. +5 more
core +2 more sources
Teaching periodontal pocket charting to dental students: a comparison of computer assisted learning and traditional tutorials [PDF]
, 2003 AIM: The aim of this study was to compare the effectiveness of a computer assisted learning (CAL) programme with that of traditional small group tutorials in teaching theoretical and practical aspects of periodontal pocket charting.
AF Fouad +9 more
core +1 more source
Current status of the application of digital impression technology in removable partial dentures [PDF]
Kouqiang yixueRemovable partial denture is one of the most important means of treating dental defects for its high strength, low price, wide range of indications, minimal trauma and repairability.
WANG Youjin, WEI Bin
doaj +1 more source
In vitro comparative study of fibroblastic behaviour on polymethacrylate (PMMA) and lithium disilicate polymer surfaces [PDF]
, 2019 Polymethyl methacrylate (PMMA) and lithium disilicate are widely used materials in the dental field. PMMA is mainly used for the manufacture of removable prostheses; however, with the incorporation of CAD-CAM technology, new applications have been ...
Castillo-Oyagüe, Raquel +5 more
core +1 more source
Journal of Pharmacy and Bioallied SciencesObjectives: To evaluate the Vickers hardness and flexural strength of computer-aided design/computer-aided manufacture (CAD/CAM) milled, 3D-printed, and traditional heat-polymerized denture base resins used in computer-aided design and manufacture ...
Mohammed Ibrahim Mathar +5 more
doaj +1 more source
The Journal of Indian Prosthodontic Society, 2020 Aim: The aim of the present study was to evaluate the improvement in oral stereognostic ability, masticatory efficiency, and difference in salivary flow rate in nonexperienced denture wearers, before, after, and 6 months after rehabilitation with ...
K Manju Mary, Babu Cherian
doaj +1 more source
Prosthetic Rehabilitation Following Lateral Resection of the Mandible with a Long Cantilever Implant-Supported Fixed Prosthesis: A 3-Year Clinical Report [PDF]
, 2017 This clinical report describes the prosthetic management of the surgical reconstruction of a patient after mandibular resection. Complete oral rehabilitation was achieved with a maxillary complete denture and a mandibular implant-supported fixed ...
Ahmed, Ayman +3 more
core +1 more source
Conversion of faulty designed fixed prosthesis into more predictable telescopic denture: a case report [PDF]
, 2021 Raja Singh, Roma Goswami
openalex +1 more source
Strength Properties of Preceramic Brazed Joints of a Gold-Palladium Alloy with a Microwave-assisted Oven and Gas/Oxygen Torch Technique [PDF]
, 2014 Statement of problem The effect of microwave brazing on the strength properties of dental casting alloys is not yet known. Purpose The purpose of this study was to compare the strength properties of preceramic brazed joints obtained by using a microwave
Dunford, Robert +3 more
core +1 more source