Results 1 to 10 of about 3,420 (211)

Effect of Fe2O3 on Electro-Deoxidation in Fe2O3-Al2O3-NaCl-KCl System

open access: yesCrystals, 2021
The reduction of Fe2O3-Al2O3 is one of the important reactions in the resource utilization of iron-containing oxide waste. Fe2O3-Al2O3 was electro-deoxidized in the NaCl-KCl system by molten salt electrolysis to prepare FeO/Al2O3. The effect of the Fe2O3
Yanke Xu   +5 more
doaj   +1 more source

Effective Deoxidation Process of Titanium Scrap Using MgCl2 Molten Salt Electrolytic

open access: yesMetals, 2021
To overcome the scarcity and resource limitations of Ti metal, deoxidation of Ti scrap was conducted through electrolytic refining and chemical reaction with MgCl2 molten salt electrolysis.
Namhun Kwon   +7 more
doaj   +1 more source

Non-wetting to Wetting Transition Temperatures of Liquid Tin on Surfaces of Different Steel Samples Corresponding to their Spontaneous Deoxidation [PDF]

open access: yesArchives of Metallurgy and Materials, 2021
The goal of this paper is to measure the non-wetting to wetting transition temperatures of liquid tin on surfaces of different steel samples in vacuum with residual pressure of 10–8 bar.
D. Varanasi   +4 more
doaj   +1 more source

Effect of sintering temperature and porosity on electro-deoxidation of calcium titanate in CaCl2-NaCl molten salt

open access: yesInternational Journal of Electrochemical Science, 2022
The performance of cathodes has an important influence on the degree of deoxidation when preparing titanium via a molten salt electro-deoxidation process.
Guoli Zhao, Ying Xu, Yanqing Cai
doaj   +1 more source

On deoxidation and modification of carbon steel

open access: yesЛитьë и металлургия, 2023
It has been shown that the elementary crystal cells of the basic products of deoxidation and modification of carbon steel, δ ferrite and austenite do not correspond to the principle of structural and dimensional correspondence of Dankov – Konobeevsky ...
E. I. Marukovich   +2 more
doaj   +1 more source

Improvement of wear-resistant properties of steel 30Н3MF with additional microalloying

open access: yesЛитьë и металлургия, 2021
One of the directions of wear resistance improvement is microalloying of improved steels. In the studies conducted, the feasibility of adjusting the composition of steel 30Н3MF was determined by additional microalloying of V + Nb in order to give it wear-
A. Z. Issagulov   +5 more
doaj   +1 more source

Metabolism Profile of Mequindox in Sea Cucumbers In Vivo Using LC-HRMS

open access: yesAntibiotics, 2022
In this work, the metabolism behavior of mequindox (MEQ) in sea cucumber in vivo was investigated using LC-HRMS. In total, nine metabolites were detected and identified as well as the precursor in sea cucumber tissues.
Xin Mao   +8 more
doaj   +1 more source

Deoxidation in molten steel by liquefied petroleum gas

open access: yes工程科学学报, 2015
Oxygen in molten steel was removed with liquefied petroleum gas in laboratory. The results show that it is feasible to use liquefied petroleum gas for deoxidation in molten steel to produce high-carbon and high-quality clean steel with VD vacuum smelting
WANG Hai-jun   +4 more
doaj   +1 more source

Mechanism of Improving Heat-Affected Zone Toughness of Steel Plate with Mg Deoxidation after High-Heat-Input Welding

open access: yesMetals, 2020
In the present study, the mechanism of improving HAZ toughness of steel plate with Mg deoxidation after the simulated welding with the heat input of 400 kJ/cm was investigated through in situ observation, characterization with SEM-EDS and TEM-EDS, and ...
Longyun Xu   +3 more
doaj   +1 more source

Control of Ds Inclusions in GCr15 Bearing Steel Based on Non-aluminum Deoxidation Process

open access: yesTeshugang, 2022
At present,the oxygen content in bearing steel has been controlled at a very low level,and Ds inclusions have become one of the main factors affecting its quality stability.In order to solve this problem,a non-aluminum deoxygenation process is proposed ...
王仲亮   +4 more
doaj  

Home - About - Disclaimer - Privacy