Results 21 to 30 of about 628,690 (265)
The effects of deposition time of Ir buffer layer on MgO(100) support layer were investigated during the fabrication of the Ir/MgO compliant substrates with the use of the magnetron sputtering technique.
Xiaodi Huo +5 more
doaj +1 more source
Incubation Time Measurements in Thin‐Film Deposition [PDF]
Studies on the initial growth or nucleation of materials and research on selective deposition often mention an incubation time. Many techniques exist to determine the incubation time. The outcome can be very different for each technique when the same nucleation process is considered.
Rem, J.B., Holleman, J., Verweij, J.F.
openaire +1 more source
The timely deposition of callose is essential for cytokinesis in Arabidopsis [PDF]
Summary The primary plant cell wall is laid down over a brief period of time during cytokinesis. Initially, a membrane network forms at the equator of a dividing cell. The cross‐wall is then assembled and remodeled within this membrane compartment.
Knut, Thiele +6 more
openaire +2 more sources
Effect of Deposition Parameters on the Supercapacitive Behavior of Electroless Ni–P Coatings
Electroless nickel–phosphorus (Ni–P) coatings were deposited on steel substrates for 20, 40, and 60 min to examine the effect of deposition time on their pseudocapacitive behavior in an alkaline electrolyte.
Szabolcs Hompoth +5 more
doaj +1 more source
This paper describes a Ag/AgCl electrochemical electrode for marine electric field measurements, which was prepared by depositing silver chloride on a silver foil substrate using double-pulse electrodeposition.
Chenjuan Wang, Yuguo Li, Yunju Wu
doaj +1 more source
Effect of Deposition Time on the Optoelectronic Properties of CdS Thin Films Synthesized via Chemical Bath Deposition Technique [PDF]
Cadmium sulphide (CdS) thin films were synthesized via chemical bath deposition (CBD) to investigate the influence of deposition time on their optoelectronic properties. The films were deposited at 80 °C for durations ranging from 5 to 30 minutes. Film
Simon Ja’afaru +4 more
doaj +1 more source
Comparison test of factors affecting wax deposition of waxy crude oil
In order to study the influence of different wax deposition factors on the wax deposition law of Daqing Crude Oil, the influence factors such as different wax deposition time, oil wall temperature difference, temperature range and shear rate were ...
Zhaoyang LIU +7 more
doaj +1 more source
Time Dependent Energy Deposition Model in RMC Kinetics Calculation [PDF]
Calculating or predicting the energy deposition in the reactor is an important task for reactor design and safety analysis. Rigorous energy deposition estimation is a difficult task because of the energy dependence, spatial dependence, and time ...
Luo Hao +6 more
doaj +1 more source
ABSTRACT A lethal round‐cell malignancy with an MN1::ZNF341 fusion has recently been reported in three infants. Here, we describe four further tumors, three in newborns (including monozygotic twins), and one in an adolescent. Detailed clinical, radiological, and histopathological data differentiate these tumors from their main mimics, neuroblastoma and
Thomas R. W. Oliver +25 more
wiley +1 more source
Towards real-time probabilistic ash deposition forecasting for New Zealand
Volcanic ashfall forecasts are highly dependent on eruption source parameters (ESPs) and synoptic weather conditions at the time and location of the eruption.
Rosa Trancoso +3 more
doaj +1 more source

