Results 211 to 220 of about 162,639 (312)

LiVO3/LiZnVO4 Nanocomposite: High Performance Electrocatalyst for Ambient Nitrogen Reduction to Ammonia

open access: yesAdvanced Engineering Materials, EarlyView.
Lithium‐mediated electrocatalysis enables sustainable N2 fixation but hindered by parasitic Li deposition. An oxide‐oxide nanocomposite (LiVO3/LiZnVO4) structurally integrates lithium into active sites, suppressing plating and enhancing N2 activation and HER supression.
Naina Goyal   +4 more
wiley   +1 more source

Is Young's Modulus a Critical Coating Property Determining Fouling‐Release Performance of Marine Coatings?

open access: yesAdvanced Engineering Materials, EarlyView.
The release of foulers from protective marine coatings is determined by several interrelated material properties, including the strength of Young's modulus, the flexibility of chain segments, the surface free energy, and the magnitude of hydrodynamic stress.
Johann C. Schaal   +2 more
wiley   +1 more source

Linking Heat Treatment to Plastic Deformation in Pearlitic Steels Through Mesoscale Modeling

open access: yesAdvanced Engineering Materials, EarlyView.
Surface wear on rail and wheel steels results from surface deformation during use. This research uses mathematical models to forecast the plastic behavior of pearlitic steels, connected to the microstructure formed during heat treatment. While the cooling rate impacts the steels’ strength, the size of prior austenite grains and blocks does not ...
Saham Sadat Sharifi   +5 more
wiley   +1 more source

Stability of Curcumin on Amphiphilic Chitosan. [PDF]

open access: yesACS Omega
Poli AL   +4 more
europepmc   +1 more source

Formation of Intermetallic Sludge Phases in AlMgSi Alloys with High Concentrations of Alloying Elements: A Drawback for Increasing Sustainability

open access: yesAdvanced Engineering Materials, EarlyView.
Sludge phases with brittle fracture behavior form in AlMgSi alloys with high concentrations of alloying elements and negatively influence their ductility. The phase type mainly depends on the Si content and the concentration of minor alloying elements like Fe, Mn, Cr, and Mo strongly influences the number of sludge particles. The need for sustainable
Dominik Steinacker   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy