Results 161 to 170 of about 1,483,458 (304)

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

O eco-feedback na interface da lavadora de roupas como estratégia de design para mudança de comportamento

InfoDesign: Brazilian Journal of Information Design, 2015
Este artigo reporta pesquisa que teve como objetivo identificar meta-requisitos para o projeto de eco-feedback em lavadoras de roupas voltadas ao morador de habitação de interesse social (HIS).
Marcelo dos Santos Forcato, Aguinaldo dos Santos   +1 more
doaj  

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

Advanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar, Dhanadeep Dutta, G. Bharat Reddy   +2 more
wiley   +1 more source

Tribological Performance of 60NiTi Alloy Under Varying Contact Conditions and Elevated Temperatures in Linear Reciprocating Sliding

Advanced Engineering Materials, EarlyView.
This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani, Miguel Angel Selles, Maziar Ramezani   +2 more
wiley   +1 more source

AI-Driven Design of Miniproteins as Potential Allosteric Modulators. [PDF]

Pharmaceuticals (Basel)
Liu X, Sun Y, Xia Y, Li H, Yan Z.
europepmc   +1 more source

Enhanced Gamma Radiation Shielding Using Epoxy Quartz Fabric Composites Reinforced With CoCl2 Microparticles

Advanced Engineering Materials, EarlyView.
The growing demand for lightweight, nontoxic, and multifunctional gamma shielding materials has intensified efforts to find alternatives to conventional lead and aluminum‐based protectants. In this work, we develop epoxy quartz fabric composites reinforced with cobalt chloride (CoCl2) microparticles, fabricated via hand lay‐up with varying filler ...
Summan Urooge, Ahsan Irshad, Umar Jamil, Srosh Fazil, Khuram Liaqat, Kashif Shahzad, Fakhar Alam, Mehboob Alam   +7 more
wiley   +1 more source

Perceived Usability as a Factor Associated with Clinical Outcomes in Mobile Health Diabetes Management: A Bayesian Mediation and Equity Analysis. [PDF]

J Clin Med
Rodríguez Montes OE, Gogeascoechea-Trejo MDC, Bermúdez-Tamayo C.   +2 more
europepmc   +1 more source

Design de interfaces dinâmicos em sistemas de gestão de conteúdos

, 2013
Este relatório está inserido no âmbito da unidade curricular de Seminário do 2º ano do Mestrado em Educação e Comunicação Multimédia (MECM) da Escola Superior de Educação do Instituto Politécnico de Santarém (ESE/IPS). O principal objetivo deste projeto é o de elaborar um estudo da integração do Design de Interfaces Dinâmicos em Sistemas de Gestão de ...
openaire   +1 more source

EBSD Study of Creep‐Induced Lattice Misorientation in MgO‐Particle‐Reinforced Austenitic Steel Composites

Advanced Engineering Materials, EarlyView.
Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller, Amaya Compart, Mahnaz Mehdizadehlima, Serhii Yaroshevskyi, Christos G. Aneziris, Horst Biermann, Anja Weidner   +6 more
wiley   +1 more source

Identifying and Prioritizing Age-Friendly Design Principles and Guidelines for Developing Transportation Planning E-Tools: Scoping Review. [PDF]

JMIR Aging
Bahrampoor Givi S, Gagnon-Roy M, Provencher V.   +2 more
europepmc   +1 more source