Developing a Construction-Oriented DfMA Deployment Framework
Buildings, 2023 Applying design for manufacture and assembly (DfMA) principles in the construction industry has gained attention in recent years. Studies convey that the application of DfMA in construction projects can significantly enhance overall productivity. However,
Sara Rankohi +3 more
doaj +1 more source
Discrete State Change Model of Manufacturing Quality to Aid Assembly Process Design
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2009 This paper proposes a representation model of the quality state change in an assembly process that can be used in a computer-aided process design system.
Tsuyoshi KOGA, Kazuhiro AOYAMA
doaj +1 more source
Method to obtain hybrid rapid tools with elementary component assembly [PDF]
, 2013 M. Rivette, P. Mognol, J.Y. Hascoet, (2013) "Method to obtain hybrid rapid tools with elementary component assembly", Rapid Prototyping Journal, Vol. 19 Iss: 2, pp.77 - 87 DOI : 10.1108/13552541311302923Purpose – The purpose of this paper is to propose a
MOGNOL, Pascal +2 more
core +1 more source
Assembly Based Methods to Support Product Innovation in Design for Additive Manufacturing: An Exploratory Case Study [PDF]
, 2015 Additive manufacturing (AM) is emerging as an important manufacturing process and a key technology for enabling innovative product development. Design for additive manufacturing (DFAM) is nowadays a major challenge to exploit properly the potential of AM
ANWER, Nabil +3 more
core +1 more source
Design and manufacturing interface modelling for manufacturing processes selection and knowledge synthesis in design [PDF]
, 2008 This research is part of the regional French project IFP2R : “ Manufacturing constraints integration in rapid prototyped part design ” with IFTS (Higher Technical Formation Institute of Charleville Mézières- France).The research results presented in this
Lionel Roucoules +5 more
core +1 more source
A methodology for the concurrent design of products and their assembly sequence [PDF]
, 1999 This thesis reports on the development of a Two-Tier methodology that provides support for assembly sequence construction, validation and evaluation in parallel with the design.
Barnes, C. J.
core +7 more sources
Simulation of an Aeronautical Product Assembly Process Driven by a Metrology Aided Virtual Approach
Metrology, 2022 Major aircraft manufacturers are expecting the commercial aircraft market to overcome the pre-COVID levels by 2025, which demands an increase in the production rate.
Gorka Kortaberria +3 more
doaj +1 more source
BuildingsImproving resource efficiency by reducing waste and process inefficiencies across the building life cycle is essential for advancing sustainability in the built environment.
Héctor Hernández
doaj +1 more source
The design of reconfigurable assembly stations for high variety and mass customisation manufacturing
South African Journal of Industrial Engineering, 2013 The economical production of mass customised and high variety goods is a challenge facing modern manufacturers. This challenge is being addressed, in part, by the on-going development of technologies that facilitate the manufacturing of these goods ...
Padayachee, Jared, Bright, G.
doaj +1 more source
Production Engineering Archives, 2023 Armoring civilian vehicles requires specialized knowledge and experience that many armoring companies lack as they are not direct or indirect suppliers of vehicle manufacturers.
Candido Guido Muzio +1 more
doaj +1 more source