Results 121 to 130 of about 825 (171)

Non-aversive Animal Restraint Enabling Recording of Optomotor Reflex in Ground Squirrels. [PDF]

J Vis Exp
Miyagishima KJ, Nadal-Nicolás FM, Ball JM, Münch T, Benkner B, Li W.   +5 more
europepmc   +1 more source

Design for Manufacturing and Assembly (DFMA) Technique Applicable for Cost Reduction - A Review

International Journal of Mechanical and Production Engineering Research and Development, 2019
openaire   +1 more source

Research on detailed design methods of precast components in prefabricated buildings based on BIM technology. [PDF]

Heliyon
Wang X, Tang Q.
europepmc   +1 more source

A review of the design process for implantable orthopedic medical devices. [PDF]

Open Biomed Eng J, 2009
Aitchison GA, Hukins DW, Parry JJ, Shepherd DE, Trotman SG.   +4 more
europepmc   +1 more source

Turning Stress Into Signal: Mechanochromic Materials in Commodity and Technologically Relevant Polymers. [PDF]

Chem Asian J
Bertoncini B, Pusceddu I, Carlotti M, Turelli M, Adamo C, Pucci A.   +5 more
europepmc   +1 more source

Recent Advances in Combining Waterborne Acrylic Dispersions with Biopolymers. [PDF]

Polymers (Basel)
Solera-Sendra J, Ballard N, Del Valle LJ, Franco L.   +3 more
europepmc   +1 more source

Design for manufacturing and assembly methods in the product development process of mechanical products: a systematic literature review [PDF]

International Journal of Advanced Manufacturing Technology, 2022
The design for manufacturing and assembly (DFMA) is a family of methods belonging to the design for X (DfX) category which goal is to optimize the manufacturing and assembly phase of products.
Giovanni Formentini, Claudio Favi, Núria Boix Rodríguez   +2 more
exaly   +2 more sources

Some of the next articles are maybe not open access.

Related searches:

Design for manufacturing and assembly (DfMA): a preliminary study of factors influencing its adoption in Singapore

Architectural Engineering and Design Management, 2018
Singapore has set an ambitious productivity improvement target for the construction industry. One recommendation is to adopt Design for Manufacturing and Assembly (DfMA) technologies to achieve thi...
Shang Gao, Sui Pheng Low
exaly   +2 more sources

Guideline tool based on design for manufacturing and assembly (DFMA) methodology for application on design and manufacturing of aircrafts

Journal of the Brazilian Society of Mechanical Sciences and Engineering, 2013
This paper presents a guideline which uses the concepts of design for manufacturing and assembly methodology for specific application on design and manufacturing of aircrafts. The main goal of this guideline was to orient the engineers during the aircraft development phases, such that a better aircraft design is achieved.
G. F. Barbosa, J. Carvalho
openaire   +1 more source