Results 181 to 190 of about 4,302,517 (347)

Assessing the Ecological Value: Monetizing Process Innovations in Tailored Forming

open access: yesAdvanced Engineering Materials, EarlyView.
This article introduces a method for evaluating the sustainability of innovations, even with limited data. The method is illustrated through an analysis of the “Tailored Forming” technology, which explores the impact of sustainability on economic value added.
Jonas Schneider   +4 more
wiley   +1 more source

Multinationals and diffrsion of technology Between developed countries [PDF]

open access: yes
This paper analyses the role played by foreign direct investment (FDI) as a mechanism through which technology flows between countries. After a short review of the existing literature it is observed that aggregate studies do not obtain evidence of the ...
Francisco Javier Velázquez   +1 more
core  

Enhanced Fog Water Harvesting on Superhydrophobic Steel Meshes

open access: yesAdvanced Engineering Materials, EarlyView.
Fog harvesting using mesh designs offers a sustainable solution to water scarcity. This study highlights key considerations for fog harvesting research and develops a methodology for a standardized protocol reflecting fog characteristics and environmental conditions.
Pegah Sartipizadeh   +3 more
wiley   +1 more source

Carbon Tax and the Industrial Sector in Developed and Developing Countries A Dynamic General Equilibrium Model [PDF]

open access: yesپژوهشهای اقتصادی
Aim and Introduction Carbon tax is one of the most important policy tools in the field of energy, which is applied to the consumption, production or distribution of fossil energy, including oil products, coal, natural gas, etc.
kolsum afshoon   +3 more
doaj  

Large Fluctuations in Consumption in Least Developed Countries [PDF]

open access: yes
The objective of this paper is to shed light on mechanism which increases fluctuation in consumption of least developed countries. In general large fluctuation in consumption makes consumers worse off. This fact suggests that accumulation of knowledge on
Kodama, Masahiro
core  

Design and Evaluation of 3D‐Printed Polylactic Acid Composites Reinforced with Biodegradable Bamboo Powder and Jute Powder

open access: yesAdvanced Engineering Materials, EarlyView.
The study investigates 3D‐printed polylactic acid (PLA) composites with biodegradable bamboo and jute powder fillers. Mechanical, thermal, structural properties, and rheological behavior are discussed to evaluate composite performance. Morphological characterization indicates uniform dispersion and adhesion of the fillers in the PLA matrix with the ...
Vimukthi Dananjaya   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy