DOMINANT HEIGHT AND AVERAGE DIAMETER AS A MEASURE OF SITE [PDF]
Harrison Parker
openalex +1 more source
Monte Carlo modeling of radiation dose from radiation therapy with superficial x‐rays
Abstract Introduction Superficial x‐rays (50–100 kVp) are used for treating non‐melanoma skin cancer and intraoperative radiation therapy (IORT). At these energies, the photoelectric effect significantly increases absorbed dose to bone compared to soft tissue.
Reham Barghash+3 more
wiley +1 more source
Measurements of white-to-white corneal diameter and anterior chamber parameters using the Pentacam AXL wave and their correlations in the adult Saudi population. [PDF]
Alotaibi WM+3 more
europepmc +1 more source
Abstract Purpose The study evaluates rapid linear accelerator (Linac) single isocenter stereotactic radiosurgery (SRS) with Hyperarc for large target numbers. We compared to Gamma Knife (GK), which suffers from long treatment times and investigated causes of differences. Methods Linac SRS and GK treatment plans for patients receiving 18 Gy to the gross
Abram Abdou+4 more
wiley +1 more source
First three new species of free-living marine nematodes of the <i>Molgolaimus</i> (Nematoda: Desmodoridae) from the continental shelf of the Brazilian coast (Atlantic Ocean). [PDF]
Manoel A, Neres PF, Esteves AM.
europepmc +1 more source
A Triangle that gives the Area and Circumference of any Circle, and the Diameter of a Circle equal in Area to any given Square [PDF]
G. B. Mathews
openalex +1 more source
Development of a generic focal spot measurement method suitable for bore‐type linacs
Abstract Purpose In linear accelerators, deviations in the x‐ray focal spot position significantly affect the accuracy of radiation therapy. However, as the focal spot position in bore‐type linac systems such as the Radixact system, cannot be assessed using conventional methods, a new evaluation method is required.
Hidetoshi Shimizu+5 more
wiley +1 more source
Wind speed and soil properties drive the height-diameter allometric pattern of island plants. [PDF]
Yang C+4 more
europepmc +1 more source
Abstract Purpose Due to the tight curvature in their design, ring applicators are usually associated with large positioning errors. The standard practice to correct for these deviations based on global offsets may not be sufficient to comply with the recommended tolerance.
Leon G. Aldrovandi+3 more
wiley +1 more source