Results 51 to 60 of about 7,236 (264)
This work reveals the influence of polymer side‐chain electronic effects on the Li+ solvation sheath in gel polymer electrolytes. Electron‐donating side chains induce the strong Li+ coordination and FDMA‐dominated solvation, impeding Li+ desolvation, whereas electron‐withdrawing side chains weaken Li+ coordination, facilitating anion‐rich solvation and
Xianbin Wu +7 more
wiley +1 more source
In this paper, the discharge characteristics of the grounded electrode uniform atomization dielectric barrier discharge reactor under the spiral wire hole electrode structure were investigated, and the optimal discharge parameters such as liquid flow ...
Zijie Zhao +5 more
doaj +1 more source
The discharge selectivity in an atmospheric pressure helium–argon dielectric barrier discharge
In this paper, an atmospheric pressure polyethylene terephthalate dielectric barrier discharge is produced in a helium–argon mixture. The influences of the electrode voltage on the discharge mode are experimentally investigated. The results show that, at
W. G. Huo +6 more
doaj +1 more source
A spatial location of atomic layer deposition (ALD)‐derived ZrO2 coatings is demonstrated to be a critical design parameter for stabilizing graphite cathodes in DIBs. Direct particle‐level ALD (PALD) screening of representative metal oxides identified ZrO2 as the coating that provides the most favorable balance of high‐rate capability and interfacial ...
Jieun Kang +7 more
wiley +1 more source
Investigation of electrical and optical properties of dielectric barrier discharge
In this paper the results of optical and electrical characteristics of dielectric barrier discharge are presented where used “plane to plane” and “pin to plane” electrode configurations.
Y.A. Ussenov +4 more
doaj
We report a chemically incorporated fluorinated AlPO4 (AlPO4‐F) architecture that functions as a multifunctional “interfacial fortress” for Li‐rich layered oxides (LLOs). By modulating the surface potential to –32.16 mV, this architecture enriches Li+ concentration and repels detrimental electrolyte anions.
Hojun Moon +13 more
wiley +1 more source
The plasma behavior in a parallel-plate dielectric barrier discharge (DBD) is simulated by a two-dimensional particle-in-cell/Monte Carlo collision model, comparing for the first time an unpacked (empty) DBD with a packed bed DBD, i.e., a DBD filled with
Ya Zhang +3 more
doaj +1 more source
Conversion‐induced sulfur expansion generates strong mechanical constraints and localized stresses within solid‐state Li‐S cathodes. Heterogeneous solid‐electrolyte confinement creates tensile strain‐energy hotspots that govern particle cracking. Larger sulfur particles accelerate fracture, while higher porosity relaxes constraint and delays damage ...
Arpan K. Sharma +3 more
wiley +1 more source
Pin Hole Discharge Creation in Na2SO4 Water Solutions
This work deals with the diaphragm discharge generated in water solutions containing Na2SO4 as a supporting electrolyte. The solution conductivity was varied in the range of 270 ÷ 750 µScm-1.
Lucie Hlavatá +4 more
doaj
Application of a zwitterionic poly(sulfobetaine methacrylate) (PSB) coating to microelectrode arrays and Ag/AgCl reference electrodes effectively inhibits biofouling and structural degradation. This strategy successfully enables simultaneous, long‐term electrophysiological recording and dopamine sensing in freely behaving mice, facilitating ...
Bingchen Wu +5 more
wiley +1 more source

