Results 11 to 20 of about 3,272,174 (382)
IET Nanodielectrics, 2020 Increasing the dielectric strength of polymer films has been a key theme as it is directly responsible for increasing energy density of relevant components such as film capacitors and insulation tapes.
Daniel Qi Tan
doaj +2 more sources
Influence of growth temperature on dielectric strength of Al2O3 thin films prepared via atomic layer deposition at low temperature. [PDF]
Sci Rep, 2022 Thin films grown via atomic layer deposition (ALD) suffer from insufficient growth rate and unreliability for temperature-sensitive electronic substrates.
Kim S +5 more
europepmc +2 more sources
Estimation of Life Cycle of Distribution Transformer in Context to Furan Content Formation, Pollution Index, and Dielectric Strength [PDF]
IEEE Access, 2021 Distribution transformer is the most vital component in the power system. Failure of a transformer leads to loss of revenue besides affecting the reliability of power supply to consumers.
Rajkumar Soni +5 more
openalex +2 more sources
Thermal Experimental Dielectric Characterization of Cost-Fewer Low-Density Polyethylene Nanocomposites [PDF]
Advances in Electrical and Electronic Engineering, 2014 Polymer properties can be experimentally tailored by adding small amounts of different fillers, but they are expensive with respect to the classical polymer materials. This paper has been studied the enhancement and controlling of electric and dielectric
Osama Gouda, Ahmed Thabet Mohamed
doaj +4 more sources
Engineering model of dielectric strength in phase‐to‐phase air gaps [PDF]
IET Generation, Transmission & Distribution, 2020 : Phase-to-phase air gap is a type of external insulation in power transmission and transformation projects. The dielectric strength of phase-to-phase air gaps affects the safety and reliability of power systems.
Jiachen Gao +5 more
openalex +2 more sources
Examination of dielectric strength of thin Parylene C films under various conditions
Current Directions in Biomedical Engineering, 2016 The breakdown voltage of the biocompatible polymer Parylene C was determined after storage in 60°C saline solution and treatment by autoclave. It occurred that both, storage at 60°C in saline solution and autoclaving, lead to distinct decrease of ...
Heid Andreas +3 more
doaj +2 more sources
How Hydrogen Dielectric Strength Forces the Work Voltage in the Electric Discharge Machining. [PDF]
Micromachines (Basel), 2018 An electro-thermal model based on the Joule heating effect is proposed to simulate a single discharge in an electric discharge machining process. Normally, the dielectric strength of the hydrocarbons oil is approximately 20 MV/m, but it varies with both ...
Almacinha JA +3 more
europepmc +2 more sources
Three-Dimensional Imaging via Time-Correlated Single-Photon Counting
Applied Sciences, 2020 Three-dimensional (3D) imaging under the condition of weak light and low signal-to-noise ratio is a challenging task. In this paper, a 3D imaging scheme based on time-correlated single-photon counting technology is proposed and demonstrated.
Chengkun Fu +8 more
doaj +1 more source
Journal of Advanced Dielectrics, 2021 The effects of polymorphic form and particle size of SiO2 fillers on the dielectric, mechanical and thermal properties of SiO2–Polyetheretherketone (SiO2–PEEK) composites were investigated in this paper. Strong low frequency (
Peng Jie Xue +2 more
doaj +1 more source
Advanced Science, 2022 Polymer dielectric capacitors are widely utilized in pulse power devices owing to their high power density. Because of the low dielectric constants of pure polymers, inorganic fillers are needed to improve their properties.
Dong Yue +7 more
doaj +1 more source