Results 111 to 120 of about 5,103 (279)
Advanced Materials, EarlyView.A reusable contact‐type pre‐lithiation platform enables uniform, precisely controllable pre‐lithiation at low stack pressure, suppressing interfacial degradation and thereby markedly improving initial Coulombic efficiency and cycling performance in all‐solid‐state batteries.
Yunho Lee +10 more
wiley +1 more source
CONTROLLING SENSITIVITY OF THE SENSOR WITH DIFFERENTIAL ELECTROSTATIC TRANSDUCERS
Приборы и методы измерений, 2015 The problem of developing a sensor for measuring of moment forces of inertia and gravitation with minimal noise and minimal rigidity of the torsion suspension of proof mass (PM) is formulated.
I. Z. Gilavdary +2 more
doaj
Advanced ScienceTerahertz (THz) electric inductive‐capacitive (ELC) resonant metamaterials (MMs) are well established tools that can be used to detect the presence of dielectric material (e.g., nanoparticles, bioparticles, etc.) spread on their surfaces within the gap ...
Heena Khand +2 more
doaj +1 more source
Sensors, 2019 This article focuses on a proposed Switched-Capacitor Dual-Slope based CDC. Special attention is paid to the measurement setup using a real pressure sensor. Performance scaling potential as well as dead zones are pointed out and discussed.
Christopher Rogi +4 more
doaj +1 more source
Long range, high sensitivity, low noise capacitive sensor for tagless indoor human localization [PDF]
, 2017 Capacitive sensors have important advantages and are widely used, but typically up to sensing distances comparable to sensor size. We present the design and experimental results of a self-contained long range capacitive sensor that is suitable for indoor
Lavagno, Luciano +7 more
core +1 more source
Advanced Materials Interfaces, EarlyView.3D conductive frameworks can maintain continuous electron transport, mechanical stability, and interfacial integrity, helping next‐generation batteries operate more efficiently. This Review examines their relevance to Si anodes, all‐solid‐state batteries, and dry‐processed electrodes, and highlights bio‐derived carbons as sustainable, structurally ...
SeoYoung Ha +5 more
wiley +1 more source
Strain Plethysmography Using a Hermetically Sealed MEMS Strain Sensor
BiosensorsWe present a hermetically sealed capacitive microelectromechanical system (MEMS) strain sensor designed for arterial pulse waveform extraction using the strain plethysmography (SPG) modality. The MEMS strain sensor features a small form factor of 3.3 mm ×
Xinyu Jiang +5 more
doaj +1 more source
A High Resolution Capacitive Sensing System for the Measurement of Water Content in Crude Oil
Sensors, 2014 This paper presents the design of a non-intrusive system to measure ultra-low water content in crude oil. The system is based on a capacitance to phase angle conversion method.
Muhammad Zubair Aslam, Tong Boon Tang
doaj +1 more source
Advanced Materials Interfaces, EarlyView.We report electrochemical quantum capacitance spectroscopy as an ambient, in situ probe for defect‐mediated electronic structure at 2D material interfaces. Using monolayer MoS2, the method resolves band edges and vacancy states, tracks sulfur‐vacancy evolution during hydrogen evolution, and links interfacial density‐of‐states changes to nearly ...
Mengyu Yan +9 more
wiley +1 more source
A 3D‐Printed Blister Test Platform for Quantifying Biointerface Adhesion Mechanisms
Advanced Materials Interfaces, EarlyView.A 3D‐printed blister platform enables energy‐resolved characterization of soft hydrogel–rigid interfaces. Integrating precision pressure control with hyperelastic modeling directly quantifies adhesion energy (G) and R‐curve toughening. Results reveal that modulating hydrogel concentration and surface roughness drives a tunable transition from cohesive ...
Yoontae Kim +4 more
wiley +1 more source