Results 321 to 330 of about 6,802,009 (374)

Diffraction efficiency of magnetic hologram

IEEE Transactions on Magnetics, 1972
MnBi thin films have been studied as a magneto-optical memory element. Ordinarily, restricted conditions are required for preparing pure MnBi film with excellent properties and homogeneity. However, in the case of Mn-Bi-Te films, it was found that adopting the proper composition made it easy to prepare homogeneous films, and the figure of merit F/α was
M. Tanaka, T. Ito, Y. Nishimura
openaire   +1 more source

Diffraction efficiency of nonsynchronously sampled diffraction gratings

Optical Engineering, 2002
This PDF contains the communication "Diffraction efficiency of nonsynchronously sampled diffraction gratings."
openaire   +1 more source

Broadband pulse compression gratings with measured 997% diffraction efficiency

Optics Letters, 2014
Martin Rumpel, Christian Moormann, Thomas Gráf   +2 more
exaly   +2 more sources

High diffraction efficiency, broadband, diffraction crystals for use in crystal diffraction lenses

Experimental Astronomy, 2006
A major goal of the MAX program is to detect and measure gamma rays produced following the nuclear reactions that take place in a supernova explosion. To detect a reasonable number of supernovae, sensitivities of the order of a few times 10-7 γ cm-2sec-1 are needed — much better than possible with current instruments. The approach in the MAX program is
Robert K. Smither, Khaliefeh Abu Saleem, Dante E. Roa, Mark A. Beno, Peter Von Ballmoos, Gerry K. Skinner   +5 more
openaire   +1 more source

Holograms of high diffraction efficiency

Soviet Journal of Quantum Electronics, 1972
An experimental study was made of the effects of bleaching on holograms. Optimal bleaching conditions made it possible to achieve a high diffraction efficiency (50%) for a hologram which recorded interference of two plane waves. In the case of a hologram of a transparency, it was important to ensure a satisfactory quality of the reconstructed image ...
V I Bobrinev, V K Kozlova, M A Maiorchuk
openaire   +1 more source

Design of multilayer diffractive optical elements with polychromatic integral diffraction efficiency

Optics Letters, 2010
What we believe to be a new method for designing multilayer diffractive optical elements (MLDOEs) for wideband with consideration of polychromatic integral diffraction efficiency (PIDE) is presented. The benefit of this method is that the maximum PIDE over the entire waveband for MLDOEs can be obtained.
Changxi, Xue, Qingfeng, Cui
openaire   +2 more sources

Efficient optimization of diffractive optical elements based on rigorous diffraction models

Journal of the Optical Society of America A, 2001
An efficient optimization strategy for the design of diffractive optical elements that is based on rigorous diffraction theory is described. The optimization algorithm combines diffraction models of different degrees of accuracy and computational complexity.
M E, Testorf, M A, Fiddy
openaire   +2 more sources

Effect of assembling errors on the diffraction efficiency for multilayer diffractive optical elements

Applied Optics, 2014
Based on the expression function of diffraction efficiency, and the phase delay function of diffractive optical elements (DOEs), the diffraction efficiency for multilayer diffractive optical elements (MLDOEs) is described with tilt and decenter assembling errors.
Long, Gao, Suet, To, Hongfang, Yang, Xin, Nie, Tianchen, Liu, Changxi, Xue   +5 more
openaire   +2 more sources

Diffraction efficiency of absorption gratings

Optical and Quantum Electronics, 1983
The diffraction efficiency of absorption gratings is investigated using a coupled multiwave analysis. For the four-wave case the analytical expressions for the signal amplitudes are given. The applicability of the four-wave approximation is also included.
openaire   +1 more source

Diffraction grating with rectangular grooves exceeding 80% diffraction efficiency

Infrared Physics, 1993
Abstract A novel design for a surface relief grating with rectangular grooves is presented. The first reflected diffraction order shows experimentally 84% diffraction efficiency for a metallic grating. The required binary surface relief can be manufactured by using one single microlithographic fabrication step similar to standard processes in ...
H. Haidner, P. Kipfer, J.T. Sheridan, J. Schwider, N. Streibl, M. Collischon, J. Hutfless, M. März   +7 more
openaire   +1 more source