Results 151 to 160 of about 232,270 (266)
Tips for Accurate Beath Pin Length Measurement While Using an Arthroscopic Jig to Avoid Neurovascular Injury Due to Over Penetration (Hit-Pat's Method). [PDF]
Patil HG, Pimprikar MV, Patil CK.
europepmc +1 more source
Deep‐UV (258 nm) femtosecond pulses enable uniform amorphous silicon writing on Si(100)/(111) with a six‐fold larger fluence amorphization window than NIR methods. Optimized fluence and overlap yield 20–45 nm uniform and continuous amorphous layers. Microscopy shows sharp interfaces, and real‐time reflectivity reveals nanosecond melt–resolidification ...
Wissal Benali +5 more
wiley +1 more source
Effect of device and expiratory maneuver technique on peak expiratory flow measurements. [PDF]
Csonka LL +3 more
europepmc +1 more source
Solvate ionic liquids lubrication reduced the coefficient of friction by ∼60% compared to dry sliding, reaching steady‐state values as low as 0.04–0.05. Corrosion weight‐loss measurements in 1 M HCl further demonstrated significant inhibition behavior, with only 100 ppm of [Li(G3)][TFSI] (∼68.5 μL/L) reducing corrosion‐product weight loss by 63 ...
Sameh Dabees +6 more
wiley +1 more source
Muscle volume of supraspinatus and infraspinatus in dogs: a computed tomography reliability study. [PDF]
Voakes AL, Reunanen V, Boström A.
europepmc +1 more source
Geometrical modifications on nitrocellulose membranes can result in observable differences in signal intensity relative to a reference membrane (top and bottom left). Using two reference experiments, we have developed a theoretical model that can reproduce the experimentally observed flow changes and provide information on membrane parameters, e.g ...
Maria Dimaki +2 more
wiley +1 more source
Morphometric Analysis of the Talocrural Joint and Lateral Ankle Ligament Complex in Human Cadavers: A Population-Specific Study. [PDF]
Kumar S, Sharma PK, Panda DK.
europepmc +1 more source
Adaptive Foam 3D Printing of Ultralight and Multifunctional Materials
Adaptive foam 3D printing, enabled by expandable microspheres, imparts cellular structures to thermoplastic and thermosetting polymers, manufactured through a variety of processes including fused filament fabrication, direct ink writing, digital light processing, and inkjet printing.
Nariman Rajabifar, Amir Ameli
wiley +1 more source
Beyond the digital divide: multi-group SEM examination of socioeconomic status, mHealth utilization, and urban-rural physical activity disparities in Indonesia. [PDF]
Sumarliah E, Mousa K, Iskandar Y.
europepmc +1 more source
An all‐in‐one analog AI accelerator is presented, enabling on‐chip training, weight retention, and long‐term inference acceleration. It leverages a BEOL‐integrated CMO/HfOx ReRAM array with low‐voltage operation (<1.5 V), multi‐bit capability over 32 states, low programming noise (10 nS), and near‐ideal weight transfer.
Donato Francesco Falcone +11 more
wiley +1 more source

