Results 141 to 150 of about 10,557,116 (346)
Advanced Engineering Materials, EarlyView.This article presents the NFDI‐MatWerk Ontology (MWO), a Basic Formal Ontology‐based framework for interoperable research data management in materials science and engineering (MSE). Covering consortium structures, research data management resources, services, and instruments, MWO enables semantic integration, Findable, Accessible, Interoperable, and ...
Hossein Beygi Nasrabadi +4 more
wiley +1 more source
IEEE AccessAging introduces sensory, motor, and cognitive challenges and limited familiarity with digital interfaces, often hindering older adults’ adoption of new technologies. Smartwatches, with their compact size and health monitoring features, promise to
Rui P. Duarte +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
, 2021 Improvements and innovations in the field of information technology are increasing day by day. Along with the parallel development and spread of the internet and mobile devices, there are significant changes in the way in which the business conducts business especially in the financial area, which is valid in all sectors of the world.
openaire +1 more source
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Applied SciencesThis paper conducts a comprehensive experimental comparison of two widely used additive manufacturing (AM) processes, Fused Deposition Modeling (FDM) and Stereolithography (SLA), under standardized conditions using the same test geometries and protocols.
Maryam Abbasi +3 more
doaj +1 more source
Assessing Access to Digital Services in Health Care-Underserved Communities in the United States: A Cross-Sectional Study. [PDF]
Mayo Clin Proc Digit Health, 2023 Cuadros DF +4 more
europepmc +1 more source
New models for digital government: the role of service brokers in driving innovation [PDF]
Executive summary Digital Government strategies are being rolled out in many Australian and international jurisdictions, ushering in a fundamentally different approach to the design and delivery of public sector services.
core
Bridging the divide: new evidence about firms and digitalisation. Bruegel Policy Contribution Issue #17 December 2019 [PDF]
, 2019 Using new evidence on the digitalisation activities of firms in the European Union and the United States, we document a trend towards digital polarisation based on firms’ use of the latest digital technologies and their plans for future investment in ...
Rückert, Désirée +2 more
core
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source