Results 161 to 170 of about 4,987 (259)

Low‐Temperature Gold Deposition Improves CdTe Back Contacts

open access: yesAdvanced Materials Interfaces, EarlyView.
Cd(Se,Te) samples are cooled during the evaporation of Au back contacts to thermally quench CdTe degradation. Reduced temperature during Au evaporation boosts PV efficiency, open‐circuit voltage, and fill factor. XPS associates these improvements with less chemical perturbation of the CdTe surface during metallization.
Christopher P. Muzzillo   +5 more
wiley   +1 more source

Morphological Characterization of Spherulites in Silk‐Polycaprolactone Mixtures: Implications for Textured Materials

open access: yesAdvanced Materials Interfaces, EarlyView.
Blending silk fibroin with polycaprolactone alters crystalline organization and surface morphology. Low fibroin levels promote ring‐banded spherulites, while higher contents generate porous, pit‐like textures, though overall crystallinity remains unchanged. Solvent evaporation further modulates surface patterns.
Karolína Kocourková   +10 more
wiley   +1 more source

Heat stress in livestock under tropical climates: impacts and mitigation strategies. [PDF]

open access: yesTrop Anim Health Prod
Jongbo AO   +7 more
europepmc   +1 more source

Large‐Scale and Cost‐Effective Fabrication of Ultra‐Thin, Biodegradable Microelectrode Arrays and Pressure Sensors Using Laser Micromachining

open access: yesAdvanced Materials Technologies, EarlyView.
A mask‐free and cost‐effective UV‐pico‐second laser‐based microfabrication method is proposed to fabricate large‐area biodegradable microelectrode arrays and pressure sensors. These devices demonstrate low impedance, good conformability, excellent biocompatibility, and rapid degradation, providing a new route for next‐generation transient electronics ...
Bhavani Prasad Yalagala   +5 more
wiley   +1 more source

Benchmarking Coaxial and Angular Optical Emission Spectroscopy With Recommendations for Reliable Compositional In Situ Monitoring During Laser Powder Bed Fusion

open access: yesAdvanced Materials Technologies, EarlyView.
ABSTRACT Real‐time insight into local chemistry is critical for reliable part quality in additive manufacturing, especially laser powder bed fusion (PBF‑LB/M), where rapid thermal cycles and localized evaporation can undermine part performance. Optical emission spectroscopy (OES) offers non‑intrusive, in situ plume monitoring, but detection geometry ...
Philipp Gabriel   +4 more
wiley   +1 more source

Flexible Pressure Sensor With Co‐Optimized Sensitivity and Linearity Based on Gradient Toroidal Microstructures

open access: yesAdvanced Materials Technologies, EarlyView.
A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy